ProForm 7.5 Distance Trainer Treadmill English Manual - Page 7

1. Make sure that the power cord is unplugged. 1 With the help of a second person, carefully tip the treadmill onto its left side. Partially fold the Frame (56) so that the treadmill is more stable; do not fully fold the Frame yet. Remove and discard the two indicated bolts (A) and the shipping bracket (B). Cut the tie securing the Upright Wire (38) to the Base (83). Locate the tie in the indicated hole in the Base, and use the tie to pull the Upright Wire out of the hole. Attach a Base Pad (81) to the Base (83) in the location shown with a Base Pad Spacer (13) and a 1" Tek Screw (2). Then, attach another Base Pad (81) with only a 1" Tek Screw (2). 2. Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4), 2 and the shipping bracket (C) from the Base (83). Attach a Wheel (84) with the Bolt and the Nut that you just removed. Do not overtighten the Nut; the Wheel must turn freely. Discard the shipping bracket. Cut the tie off the Upright Wire (38). B Hole 83 56 13 81 2 Tie 38 83 4 A 38 81 2 Tie 84 C 8 3. Identify the Right Upright (78) and the Right 3 Upright Spacer (79), which are marked with stickers. Insert the Upright Wire (38) through the 78 Right Upright Spacer as shown. See the inset drawing. Tie the long tie in the 38 Right Upright (78) securely around the end of 38 the Upright Wire (38). With the help of a second person, hold the Right Upright near the Base (83). Then, pull the other end of the long tie until 79 Long Tie the Upright Wire is routed completely through the Right Upright. 83 78 38 Long Tie 7