ProForm 740 Ekg Bike Uk Manual - Page 4
Assembly
View all ProForm 740 Ekg Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
ASSEMBLY Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included tools and your own adjustable spanner driver . and Phillips screw- Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 14. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the parts bag, check to see if it has been preassembled. M8 Nylon Locknut (10)-6 M10 Nylon Locknut (33)-4 M8 Split Washer (41)-10 M4 x 16mm Screw (49)-4 M6 x 8mm Screw (28)-2 M8 x 25mm Button Screw (45)-6 M10 x 75mm Carriage Bolt (30)-4 1. Identify the Front Stabiliser (2). See the inset drawing. Attach a Wheel (14) to one end of the Front Stabiliser with an M8 Nylon Locknut (10). Make sure that the Wheel is turned as shown and that it turns freely. Next, align the four plastic posts on a Wheel Cover (23) with the plastic posts on the Wheel, and press the Wheel Cover onto the Wheel. Assemble the other Wheel (not shown) in the same way. Whilst another person lifts the front of the Frame (1), attach the Front Stabiliser (2) to the Frame with two M10 x 75mm Carriage Bolts (30) and two M10 Nylon Locknuts (33) as shown. 2. Whilst another person lifts the rear of the Frame (1), attach the Rear Stabiliser (6) with two M10 x 75mm Carriage Bolts (30) and two M10 Nylon Locknuts (33). 4 1 2 30 2 33 1 1 33 14 2 23 10 Post 33 6 30