ProForm 750cs English Manual - Page 16

During the CD or video program, an electronic "chirping" sound will alert you when the speed and/or incline of the treadmill is about to change. CAUTION: Always listen for the "chirp" and be prepared for speed and/or incline changes. In some instances, the speed and/or incline may change before the personal trainer describes the change. If the speed or incline settings are too high or too low, you can manually override the settings at any time by pressing the SPEED or INCLINE buttons on the console. However, when the next "chirp" is heard, the speed and/or incline will change to the next settings of the CD or video program. To stop the program at any time, press the STOP button on the console. The TIME display will begin to flash. To restart the program, press the START button or the SPEED v button. After a moment, the walking belt will begin to move at 1 mph. When the next "chirp" is heard, the speed and incline will change to the next settings of the CD or video program. When the CD or video program is completed, the walking belt will stop and the TIME display will begin to flash. Note: To use another CD or video program, press the STOP button or remove the key and go to step 1 on page 15. Note: If the speed or incline of the treadmill does not change when a "chirp" is heard: • Make sure that the iFIT.com indicator is lit and that the TIME display is not flashing. If the TIME display is flashing, press the START button or the SPEED v button on the console. • Make sure that the audio cable is properly connected, that it is fully plugged in, and that it is not wrapped around a power cord. • If you are using your portable CD player and the CD skips, set the CD player on the floor or another flat surface instead of on the console. 5 Follow your progress with the LED track and the four displays. See step 5 on page 10. 6 Measure your heart rate, if desired. See step 6 on page 11. 7 When the iFIT.com CD or video program is finished, remove the key. When the program has ended, make sure that the treadmill is at the lowest incline level. Next, remove the key from the console and put it in a secure place. Note: If the displays and indicators on the console remain lit after the key is removed, the console is in the "demo" mode. Refer to page 18 and turn off the demo mode. When you are finished using the treadmill, move the on/off switch near the power cord to the off position. CAUTION: Always remove iFIT.com CD's and videocassettes from your CD player or VCR when you are finished using them. • Adjust the volume of your CD player or VCR. If the volume is too high or too low, the console may not detect the program signals. 16