ProForm 870e Uk Manual - Page 10

4. Identify the Left Pedal (20); there is an "L" on the Left Pedal for identification. Using an adjustable 4 wrench, tighten the Left Pedal counterclockwise into 22 the left arm of the Crank (22). Tighten the Right Pedal (not shown) clockwise into 20 the right arm of the Crank (22). 5. Hold the Handlebar Post (19) near the Frame (13) as shown. Feed the Resistance Cable (6) and the Reed Switch Wire (4) into the Frame, and then slide the Handlebar Post into the Frame. Be careful not to pinch the Resistance Cable or the Reed Switch Wire. Attach the Handlebar Post with three M10 x 22mm Button Head Bolts (55) and three M10 Lock Washers (61). The Console (5) requires two 1.5V batteries (not included). Alkaline batteries are recommended. Refer to the inset drawing. Locate the battery door on the back of the Console. Slide the battery door to the left and open it as shown. Press two batteries into the battery clip, with the negative (-) ends of the batteries touching the springs. Close the battery door and slide it to the right. 6. Attach the Handlebar (18) to the Handlebar Post (19) with two M10 x 22mm Button Head Bolts (55) and two M10 Lock Washers (61). 5 4 6 61 55 6 55 5 19 55 Battery 5 Door 61 55 13 Batteries Battery Clip 61 18 19 6