ProForm Space Saver 695 Elliptical Uk Manual - Page 7
an M8 Split Washer 90, and an M8 Locknut
View all ProForm Space Saver 695 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4. Hold a Crank Arm (36) against the left Crank Hub (38), and align the holes in the Crank Arm 4 with the unused holes in the Crank Hub. Next, insert four Hub Screws (87) through a 98 36 Hub Cover (75) into the Crank Arm (36), and finger tighten the Hub Screws into the left Crank 38 Hub (38). Tighten one of the Hub Screws, and then tighten the Hub Screw farthest from the first Hub Screw. Then, tighten the remaining two Hub Screws. 75 87 Repeat this step on the other side of the elliptical exerciser. Make sure that the Crank Arms (36) are oriented as shown. Note: There are no Pulley Screws (98) on the right side. 87 36 5. While another person holds the Upright (3), connect the Upper Wire Harness (48) to the 5 Lower Wire Harness (49). Gently pull the upper end of the Upper Wire Harness (48) to remove any slack, and insert the Upright (3) into the Base (1). Tip: Avoid pinching the wires. Attach the Upright (3) with an M8 x 71mm Button Bolt (80), an M8 Split Washer (90), and an M8 Locknut (78). Make sure that the Locknut is in the hexagonal hole in the Base (1). Next, tighten two M8 x 23mm Button Screws (84) and two M8 Split Washers (90) into the Base (1). Avoid pinching the wires 3 48 49 78 84 90 1 80 90 90 84 7