ProForm Style 6500 Treadmill Uk Manual - Page 9
Sole May Be Damaged When You Turn
View all ProForm Style 6500 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
6. Set the Console (68) face down on a soft surface to avoid scratching the Console. Hold the Right Handrail (40) near the Console as shown. Insert the console wire into the large hole on the side of the Right Handrail and out the hole on top as shown. Attach the Right Handrail (40) with three #8 x 3/4" Screws (3). Make sure that no wires are pinched. Start all three Screws before tightening any of them. Do not overtighten the Screws. Next, attach the console ground wire to the Right Handrail (40) with a #8 x 1/2" Silver Screw (10). Then, attach the Left Handrail (not shown) to the other side of the Console (68) as described above. Note: There are no wires on the other side of the Console. 6 Large Hole 3 40 Console Ground Wire 10 7. Connect the Upright Wire (69) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN YOU TURN ON THE POWER. Insert the connectors and excess wire into the Right Upright (39). Next, set the Right Handrail (40) and the Left Handrail (not shown), with the Console (68), onto the top of the Right Upright (39) and the Left Upright (not shown). Make sure that no wires are pinched. 7 68 40 69 Console Wire 39 Console Wire 3 3 68 69 9