ProForm Xp Trainer 580 Treadmill User Manual - Page 7

1. Make sure that the power cord is unplugged. 1 With the help of a second person, carefully tip the treadmill onto its left side. Partially fold the Frame (51) so that the treadmill is more stable; do not fully fold the Frame yet. Cut the shipping tie securing the Upright Wire (79) to the Base (87). Locate the plastic tie in the indicated hole in the Base, and use the tie to pull the Upright Wire out of the hole. Attach two Base Feet (84) to the Base (87) in the locations shown with two Base Foot Spacers (89) and two #8 x 1" Tek Screws (4). Then, attach the other two Base Feet (84) with two #8 x 1" Tek Screws (4). Hole 79 89 51 84 4 2. Attach a Wheel (88) with a 3/8" x 2" Bolt (7) and 2 a 3/8" Nut (11) to the Base (87). Do not over- tighten the Nut; the Wheel must turn freely. 84 89 4 7 87 88 11 3. Identify the Right Upright (80) and the Right Upright Spacer (82), which are marked with stickers. Insert the Upright Wire (79) through the Right Upright Spacer as shown. Set the Right Upright Spacer on the Base (87). See the inset drawing. Tie the wire tie in the Right Upright (80) securely around the end of the Upright Wire (79). With the help of a second person, hold the Right Upright near the Base (87). Then, pull the other end of the wire tie until the Upright Wire is routed completely through the Right Upright. 3 79 79 7 Wire Tie 80 Wire Tie 87 84 4 84 4 80 79 82 87