RCA RT2600 User Guide - Page 24

Advanced Sound Control Fine Setting of the Speakers 4. Press LEVEL again to save your setting. This receiver supports a wide range of speakers and 5. Repeat step 3 to adjust other speaker volume lev- EN subwoofers. For optimal surround sound enjoyment, els. you need to register the speaker selection settings of your audio system. If you buy this receiver with accompanied speaker package, then this step has NOTE been done for you. Also, to make the surround sound more effective and suit the acoustic conditions in your listening room, you need to delay the signal from some of the speakers. Such channel delay compensates for center or surround speakers that are closer to listening position than the front speakers. You can make use of the SETUP button to adjust the speakers' relative loudness. To adjust the level of all speakers (center and surround speakers), you must select Pro Logic mode first by pressing the SURROUND key Advanced Setting Factory defaulted Advance setting indication from VFD The TEST TONE button You can adjust the relative loudness of the individual speakers by the TEST TONE button. 1. In Surround (Dolby Digital/Pro Logic/DTS) modes, press TEST TONE briefly. A short noise will be heard in the speakers one by one. The speaker having the noise at that moment will be shown in the display. S SETUP TEST TONE EQ DIGITAL INPUT OK ST / MONO The receiver has defaulted the following distances: Front Left Lch L/S Rear Left Center Cch Front Right Rch R/S Rear Right Front speakers (L/R) 15 ft Center speaker (Cch) 15 ft Rear speaker (SUR) 10 ft 2. To adjust the volume level of the test tone, turn up/down the VOLUME knob or press VOL UP/DOWN key on the remote control. VOLUME Speaker Configurations You can also change the setup of the speakers by pressing the SETUP button until the display shows L/R SML or L/R LRG which enables you to set the size of the front speaker. Available Selections: MODE MODE BASS/TREBLE LEVEL 3. To adjust individual speaker volume level, press the LEVEL key on the main unit when the short noise is played on the speaker you want to adjust then turn the VOLUME knob to modify the output level. BASS/TREBLE LEVEL V-AUX VIDEO L - AUDIO - R Front Speaker selection Center Speaker selection Surround Speaker selection Subwoofer selection Subwoofer Phase Front Speaker distance Centre Speaker distance Rear Speaker distance Large/ Small Large/ Small/ None Large/ Small/ None Yes/ No + / 3-40 ft 0-40 ft 0-40 ft Pressing SETUP button once, while the display is still showing L/R LRG, you may press the OK button to toggle among: front, center, surround, subwoofer, subwoofer phase and speakers' distance, sleep and dimmer setup. Set the speaker size or speakers' distance by pressing UP/DOWN ARROW button. 21