RCA RT2600 User Guide - Page 25

Advance Sound Control NOTE • The sub-woofer selection will always be YES when the main speakers are set to small (SML). • For the subwoofer phase setting, it will be affected by how you locate the subwoofer. Try both + and - settings and select the one that has better bass effect. • If your unit comes with speakers, always set all speakers size to "small" to protect them and optimize the sound quality. • When left and right front speakers are set to SMALL, center and surround speakers can not be set to LARGE. Use a subwoofer to enjoy optimum sound. • Subwoofer Phase: Try both settings and select the sound preferred. • Speaker distance: For optimum surround experience measure the distance between the speaker and your favorite listening position. 1. Press SETUP once. Speaker Icons The receiver shows you the speakers' types and settings on the display with the following icons: L R Large front speakers LR C Small front speakers Large center speaker C LS RS Small center speaker Large rear speakers LS RS Small rear speakers LFE Subwoofer present Displaying Program Formats When a digital source is playing, the receiver will automatically switch to the proper surround mode and indicates on the speaker icons on the right-hand side of the display. (See diagram) SETUP TEST TONE EQ DIGITAL IN OK ST / MO LCR LS LFE RS 2. While the VFD display is showing L/R SML, press UP/DOWN ARROW button to select. MEMORY OK SETUP TEST TONE It is important to note, however, that not all Dolby Digital sources are encoded with the full complement of five channels plus LFE*. Speaker icons show how many and which speaker you have enabled (See "Fine Setting of the Speakers") and the letters inside the speaker icons show which channel is present in the source information. For example, the diagram shown means you have all the five speakers and subwoofer enabled and the digital sources you played have five channels plus LFE complemented. 3. Press OK button once to move to the next speaker setting. * LFE stands for Low Frequency Effect. The indication "LFE" appears if the digital source contains LFE information. In this case, the bass signal will be delivered 4. Repeat step 3 to set up the next speaker to the subwoofer, offering more dynamic deep bass sound effects. If the letter is flashing, the signal is 5. When set up is done, either too weak or just gone. wait for 5 seconds to automatically save your settings or press any key to save your selection SOURCE SOURCE FM/AM TUNIN and set up mode. 22