Reebok 825 English Manual - Page 15
Miscellaneous Assembly
View all Reebok 825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Miscellaneous Assembly 26 26. Note: Some of the parts used in miscellaneous assembly are located in the parts bag labeled ÒSeat Assembly.Ó 38 Slide the four Tinnerman Clips (38) down over the slots in the bracket on the Stabilizer (5). 5 38 27. Attach the upper end of the Shroud (56) to the two 27 ÒLÓ-brackets on the Top Frame (1) with two 1/4Ó x 3/4Ó 1 17 Bolts (17), two 1/4Ó Flat Washers (71) and two 1/4Ó Nylon Locknuts (25). ÒLÓ-Bracket Note: Line up the indicated corner of the Shroud (56) with the indicated corner of the Top Frame (1). The Bolts (17) go through the square holes in the Shroud. Do not tighten the Bolts yet. Line Up Corners 71 71 25 17 28. Attach the lower end of the Shroud (56) to the bracket 28 on the Stabilizer (5) with four #8 x 3/4Ó Screws (32). The Screws go through the square holes in the Shroud and into the Tinnerman Clips (38). 5 Note: For the sake of clarity, this step shows the Shroud as if step 27 had not yet been performed. 56 38 38 Bracket 32 56 32 32 29. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 17 of this manual. Before using the training system, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLESHOOTING AND MAINTENANCE on page 19. 15