Reebok 825 English Manual - Page 9

8. Remove the upper of the two 3/8Ó x 3Ó Bolts (45) attaching the Top Frame (1) to the Main Upright (3). Feed the bolt on the High Cable (73) through the indicated slot in the Main Upright (3) in the direction shown. Note: Follow the procedure described in step 7 for attaching all Pulleys. Wrap the High Cable (73) around a 4Ó Pulley (35) in the direction shown. Attach the Pulley to the Main Upright (3) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55), two Pulley Bushings (42) and a 3/8Ó Nylon Jamnut (63). Re-insert the 3/8Ó x 3Ó Bolt (45), and secure it with a 3/8Ó Nylon Locknut (50). Note: The Cable must be seated in the groove of the Pulley before the Bolt is attached. 9. Remove the lower of the two pre-assembled Pulleys (35) on the Press Frame (12). Put the Pulley, the 3/8Ó x 8 1/2Ó Bolt (59) and the 3/8Ó Nylon Locknut (50) aside. Wrap the High Cable (73) around the remaining of the two pre-assembled Pulleys in the direction shown. Feed the bolt on the High Cable (73) through the indicated slot in the Main Upright (3) in the direction shown. Wrap the High Cable (73) around a 4Ó Pulley (35). Attach the Pulley to the Main Upright (3) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55), two Pulley Bushings (42) and a 3/8Ó Nylon Jamnut (63). 8 35 45 55 54 Slot 50 42 1 73 42 63 55 3 Bolt 9 73 35 54 42 55 42 55 63 50 Bolt 59 Slot 12 3 Lower Preassembled Pulley (35) 10. Feed the bolt on the High Cable (73) through the indicated slot in the Main Upright (3) in the direction shown. The Cable should wrap around the Pulley that was attached in step 9. Wrap the High Cable around the Pulley (35) that was removed from the Press Frame (12) in step 9. The Cable must wrap around the Pulley in the direction shown. Attach the Pulley (35) to the Press Frame (12) with the 3/8Ó x 8 1/2Ó Bolt (59) and the 3/8Ó Nylon Locknut (50). Feed the bolt on the High Cable (73) back through the slot in the Main Upright (3) in the direction shown. 10 Slot 50 Bolt 73 12 3 59 35 9