Ricoh 3045 Operating Instructions - Page 30
Copying from the Bypass Tray
View all Ricoh 3045 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Copying Copying from the Bypass Tray Use the bypass tray to copy onto OHP ❒ The machine can automatically de- transparencies, adhesive labels, trans- tect the following sizes as standard lucent paper, postcards and copy pa- size copy paper: per that cannot be loaded in the paper 2 trays. Metric A3L, A4KL, A5KL, version 81/2" u 13"L Preparation When the duplex unit is attached, the default is [1 Sidedo2 Sided]. When copying from the bypass tray, select [1 Sided] for copying in [Dup./Combine/Series] (for example [1 Sidedo1 Sided] or [2 Sidedo1 Sided] ). You can change the initial settings. See p.94 "Duplex Mode Priority" . Inch A3L, 11" u 17"L, 81/2" u 11"KL, version 51/2" u81/2"L ❒ When copying on OHP transparencies or paper heavier than 128 g/m2 (about 34 lb.), you need to specify the paper type. See p.22 "When copying onto special paper" . ❒ The maximum number of sheets Important you can load at the same time depends on paper type. The maxi- ❒ When paper larger than 433 mm in mum number of sheets should not size is used, the paper may become exceed the upper limit. A wrinkled, may not be fed into the machine, or may cause paper jams. Open the bypass tray. Note ❒ If you do not use the standard size copy paper or if you use special paper, you should input vertical and horizontal dimensions. See p.16 "Placing custom size originals". The sizes that you can input are as follows: Metric • Vertical: 100-297 mm version • Horizontal: 148-600 mm *1 Inch • Vertical: 3.9"-11.6" version • Horizontal: 5.8"-23.4" *1 ZDSH110J *1 The range is 148-432 mm (5.8"-17") when the booklet finisher is installed. 20