Ryobi A25RT02 English Manual - Page 12
Attaching The Router To The Table
View all Ryobi A25RT02 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
ASSEMBLY PRE-DRILLING HOLES FOR THROUGH TABLE DEPTH ADJUSTMENT See Figure 8. Since each router will have different placements for through table depth adjustments, pilot holes have been pre-drilled in the throat plate to assist in through table adjustments. Only the models listed below in the key are available for use with the through table depth adjustment feature. Remove the throat plate. Determine which router you have and find the pre-drilled pilot hole that matches your router. (Refer to the key below.) Using a drill and drill bit, drill a hole through the pilot hole large enough for the depth adjustment tool (not included with router table, but may be included with your router) to pass though so through table depth adjustments can be made. Figure 8 Key: RD: RIDGID R2930 RY: Ryobi R163K ML: Milwaukee 5615-20, 5616-20 PC1: Porter-Cable 890 Series PC2: Porter-Cable 8529 ATTACHING THE ROUTER TO THE TABLE For ease of use, assemble the router to the insert plate with the insert plate removed first, then install the insert plate/ router assembly into the router table. ATTACHING THE ROUTER TO THE INSERT PLATE See Figures 9 - 10. Remove the insert plate. Remove the subbase plate from the router. Using the following chart for reference, and using one of the three included sets of three router insert plate screws, attach the router to the insert plate with the pilot holes facing the router and the notch in the insert plate facing the back of the router table. NOTE: When attaching insert plate to the router, make sure the holes in the router base match up with the insert plate accurately and are not off-center. INSTALLING THE ROUTER/INSERT PLATE ASSEMBLY See Figure 11. With the insert plate installed on the router, insert router and insert plate assembly into the router table with the notch in the insert plate facing the back of the router table toward the fence assembly. Install the insert plate screws and leave loose until all adjustments have been made. PRE-DRILLED PILOT HOLES RD INSERT PLATE REAR SIDE ML PC2 RY PC1 PC1 Fig. 8 INSERT PLATE FRONT SIDE B4 A6 A5 A1 NOTCH A2 B1 B2 B3 A3 A4 Fig. 9 ROUTER INSERT PLATE SCREWS 3 2 1 0 1 Inch INSERT PLATE Fig. 10 INSERT PLATE SCREWS NOTCH DIFREEECDTION 3 2 1 0 1 Fig. Inch 11 12