Ryobi A25RT02 English Manual - Page 15
Attaching The Featherboard, Inserting The Starting Pin, Installing The Miter Gauge
View all Ryobi A25RT02 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ASSEMBLY Unplug the router table and/or the router. Select the throat plate you wish to use. Press throat plate into insert plate slot until it snaps into place. 3 2 To remove, push throat plate out from1 0 1 the bottom of the Inch insert plate. ATTACHING THE FEATHERBOARD See Figure 15. Unplug the router table and/or the router. Insert the featherboard bolts through the slots in the fence assembly. Slide the featherboard over the featherboard bolts. Install the fence lock knobs and carriage bolt washers over the carriage bolts. Tighten the fence lock knobs. INSERTING THE STARTING PIN See Figure 16. Place the starting pin on the router table and use it as a pivot point when cutting small, odd-shaped pieces. NOTE: It is not necessary to use the fence when you are using the starting pin, but the bit guard should be used to 0 cover the cutter. Additionally, only use piloted cutters whe1n using the starting pin. Inch Unplug the router table and/or the router. Place the starting pin into the hole to the right of the router table throat opening. Push the pin in to secure. INSTALLING THE MITER GAUGE See Figure 17. Unplug the router table and/or the router. With the router table right side up, and the front edge closest to you, place the miter gauge bar in the slot near the front of the table with the pointer on the right. FENCE LOCK KNOB 3 2 1 MITER GAUGE BAR SLOT FEATHERBOARD BOLT 3 2 1 0 1 Inch FEATHERBOARD CARRIAGE BOLT WASHER Fig. 15 STARTING PIN INSTALL STARTING PIN HOLES REMOVE 3 2 1 0 1 Inch DIF Fig. 16 MITER GAUGE 3 2 1 0 1 Inch POINTER 3 2 1 0 DIFREEECDTION Inch 1 SLOT 15 Fig. 17