Ryobi A25RT02 English Manual - Page 18
Warning, Adjusting The Miter Gauge, Positioning The Fence - router table manual
View all Ryobi A25RT02 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
OPERATION INSERTING/REMOVING CUTTERS Unplug the router table and/or the router. Remove the router/insert plate assembly. (See Installing Router/Insert Plate Assembly in the Assembly section.) WARNING: 3 2 1 0 1 Inch If you are changing a cutter immediately after use, be careful not to touch the cutter or collet with your hands or fingers. They will get burned because of the heat buildup from cutting. Always use a wrench. MITER GAUGE KNOB 3 2 1 0 1 Inch Consult the router operator's manual for proper cutter removal/installation procedure and replace cutter. ADJUSTING DEPTH OF CUT We recommend that cuts be made at a depth not exceeding 1/8 in. and that several passes be made to reach depths of cut greater than 1/8 in. ADJUSTING THE MITER GAUGE See Figure 21. Unplug the router table and/or the router. Loosen the miter gauge knob. Rotate the miter gauge to the desired angle. Tighten the miter gauge knob. POSITIONING THE FENCE See Figure 22. The fence enables you to support and guide the workpiece. Unplug the router table and/or the router. Loosen the fence lock knobs. Position the fence to the desired location. Tighten the fence lock knobs. NOTE: The outfeed fence has joining capabilities and can be adjusted out in increments up to 1/4 in. and enable you to support the workpiece as it exits the cutter. WARNING: 3 2 1 When making a side or edge cut, never position the fen1 c0e Inch such that the workpiece is located between the cutter and the fence. Failure to heed this warning can result in serious personal injury. MITER GAUGE OUTFEED FENCE Fig. 21 1 Inch FEDEIDRECTION LOOSEN 0 1/4 FENCE LOCK KNOBS TIGHTEN SCALE CUTTER PROPER DISTANCE DIFREEECDTION 3 2 3 1 2 0 1 Inch SCALE Fig. 22 18