Ryobi BG828G User Manual 3 - Page 10
Maintenance - parts
View all Ryobi BG828G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
MAINTENANCE WARNING: When servicing, use only identical replacement parts. Use of any other parts could create a hazard or cause product damage. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes resulting in possible serious injury. GENERAL MAINTENANCE Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. WARNING: Do not at any time let brake fluids, gasoline, petroleumbased products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which could result in serious personal injury. LUBRICATION All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrication is required. POWER SUPPLY CORD REPLACEMENT If replacement of the power supply cord is necessary, this must be done by an authorized service center in order to avoid a safety hazard. WHEEL REPLACEMENT See Figure 14, page 13. If you must replace a grinding wheel, be sure to obtain one with a safe rated speed at least as high as the "no load speed" RPM marked on the data plate of the grinder and which is marked to comply with ANSI B7.1. To replace the grinding wheel: Unplug the grinder. Remove the flange nuts and screws securing the wheel guard cover. Remove the wheel guard cover. Loosen the wheel nut in a clockwise direction for the left side and a counterclockwise direction for the right side. Remove the outer flange and grinding wheel. To install a new grinding wheel, reverse the above procedure. NOTE: Be sure the grinding wheel and outer flange are properly seated on the spindle shaft. installing wire wheel (not included) See Figure 15, page 13. When replacing the grinding wheel with a wire wheel, it is necessary to place a spacer on the spindle shaft BEFORE installing the inner flange, wheel, outer flange, and wheel nut. NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 10 AFTER FRENCH AND SPANISH LANGUAGE SECTIONS. This product has a Three-year Limited Warranty. For Warranty details go to www.ryobitools.com 10 − English