Ryobi P631K Operation Manual - Page 10
Maintenance
View all Ryobi P631K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
MAINTENANCE WARNING: When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in fluids entering your eyes resulting in possible serious injury. MAINTENANCE procedures note: Always remove the battery pack from the unit before attempting a service operation. Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. WARNING: Do not at any time let brake fluids, gasoline, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken, or destroy plastic which may result in serious personal injury. cleaning the sprayer for storage See Figures 8 - 9, page 13. When you've finished your project and are ready to store the sprayer, a thorough cleaning and lubrication is recommended. Remove the battery pack from the sprayer. Remove the paint container. If you haven't already done so, return any unused paint or stain to its original container. Fill the paint container with lukewarm water (following the use of latex products) or Klean-Strip® Revolutionary White Formula Paint Thinner, Klean-Strip® Green Safer Paint Thinner, Crown® Paint Thinner NEXT, or any other non-flammable paint thinner (following the use of oil-based products). Reinstall the paint container. Install the battery pack in the sprayer. Spray the solution onto a piece of cardboard or other scrap material. Continue spraying until all the solution is used. Remove the battery pack from the sprayer. Remove the paint container. Remove the suction tube and filter. Remove the installed spray tip by turning it counterclockwise. Remove the atomizer valve assembly. Remove the locking nut by turning it counterclockwise. Slide the pump housing assembly/container lid forward off the sprayer. Pull the piston and spring off the pump housing. Using the cleaning brush provided and the solution deter- mined by the last type of paint or stain sprayed, clean all of the above parts thoroughly. NOTE: Make sure to scrub thoroughly inside the pump housing opening so that no paint or stain material is left behind. Clean the vent hole in the pump housing using a straightened paper clip or toothpick. To reassemble: Place a line of lubricant on the piston. Slide the spring back onto the piston. Insert the piston and spring assembly inside the back of the pump housing. Replace the pump housing assembly/container lid into the sprayer. Replace the locking nut on the motor housing by pushing in while rotating clockwise to secure. Insert the atomizer valve assembly into the pump housing front opening. Replace the spray tip and rotate clockwise to secure. Reinstall the suction tube and filter. Reinstall the paint container. The sprayer is now ready to be stored. replacing atomizer valve assembly See Figure 10, page 13. The atomizer valve causes the paint or stain material to spin as it comes out of the sprayer. After 7 to 10 gallons of paint or stain, the atomizer valve may no longer produce a good spray pattern and may need to be replaced. To replace: Remove the battery pack from the sprayer. Rotate the spray tip counterclockwise and remove. Remove the atomizer valve assembly and discard. Install the new atomizer valve assembly. Replace the spray tip and rotate clockwise to secure. BATTERY PACK REMOVAL AND PREPARATION FOR RECYCLING WARNING: Upon removal, cover the battery pack's terminals with heavy-duty adhesive tape. Do not attempt to destroy or disassemble battery pack or remove any of its components. Lithium-ion and nickel-cadmium batteries must be recycled or disposed of properly. Also, never touch both terminals with metal objects and/or body parts as short circuit may result. Keep away from children. Failure to comply with these warnings could result in fire and/or serious injury. 10 - English