Ryobi RY34421 Operator's Manual - Page 11

ASSEMBLY UNPACKING This product requires assembly. n Carefully remove the product and any accessories from the box. Make sure that all items listed in the packing list are included. WARNING: To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts. WARNING: Do not use this product if any parts on the packing list are already assembled to your product when you unpack it. Parts on this list are not assembled to the product by the manufacturer and require customer installation. Use of a product that may have been improperly assembled could result in serious personal injury. n Inspect the product carefully to make sure no breakage or damage occurred during shipping. n Do not discard the packing material until you have carefully inspected and satisfactorily operated the product. n If any parts are damaged or missing, please call 1-800-860-4050 for assistance. PACKING LIST C430 Trimmer Assembly Dual Spool™ Fixed Line Adaptor Front Handle Curved Shaft Grass Deflector Bottle of 4-Cycle Lubricant Paper Funnel Hanger Cap Operator's Manual S430 Trimmer Assembly Dual Spool™ Fixed Line Adaptor Front Handle Straight Shaft Grass Deflector Bottle of 4-Cycle Lubricant Paper Funnel Hanger Cap Operator's Manual WARNING: If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury. WARNING: Do not attempt to modify this product or create accessories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. INSTALLING THE POWER HEAD TO THE ATTACHMENT See Figures 2 - 3. WARNING: Never install, remove, or adjust any attachment while power head is running. Failure to stop the engine can cause serious personal injury. The attachment connects to the power head by means of a coupler device.  Stop the engine and disconnect the spark plug wire.  Loosen the knob on the coupler of the power head shaft and remove the end cap from the attachment.  Push in the button located on the attachment shaft. Align the button with the guide recess on the power head coupler and slide the two shafts together. Rotate the attachment shaft until the button locks into the positioning hole. NOTE: If the button does not release completely in the positioning hole, the shafts are not locked into place. Slightly rotate from side to side until the button is locked into place.  Tighten the knob securely. WARNING: Be certain the knob is fully tightened before operating equipment; check it periodically for tightness during use to avoid serious personal injury. REMOVING THE ATTACHMENT FROM THE POWER HEAD For removing or changing the attachment:  Stop the engine and disconnect the spark plug wire.  Loosen the knob.  Push in the button and twist the shafts to remove and separate ends. ATTACHING THE STORAGE HANGER See Figure 4. There are two ways to hang your attachment for storage.  To use the hanger cap, push in the button and place the hanger cap over end of the lower end attachment shaft. Slightly rotate the cap from side to side until the button locks into place. 7 - English