Ryobi TS1142L User Manual - Page 16
Dust Bag, Work Clamp, Warning, Installing Batteries In Laser
View all Ryobi TS1142L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
ASSEMBLY DUST BAG See Figure 11. A dust bag is provided for use on this miter saw. It fits over the exhaust port on the upper blade guard. To install, squeeze the two metal clips to open the mouth of the bag and slide it on the exhaust port. Release the clips. The metal ring in the bag should lock in between the grooves on the exhaust port. To remove the dust bag for emptying, simply reverse the above procedure. WORK CLAMP See Figure 12. The work clamp provides greater control by clamping the workpiece to the fence or the table. It also prevents the workpiece from creeping toward the saw blade. This is very helpful when cutting compound miters. Depending on the cutting operation and the size of the workpiece, it may be necessary to use a C-clamp instead of the work clamp to secure the workpiece prior to making the cut. WARNING: In some operations, the work clamp assembly can interfere with the operation of the blade guard assembly. Always make sure there is no interference with the blade guard prior to beginning any cutting operation to reduce the risk of serious personal injury. To install the work clamp: Place the shaft of the work clamp in either hole on the saw table base. Rotate the knob on the work clamp to move it in or out as needed. INSTALLing BATTERIES IN LASER See Figure 13. Remove screw from battery compartment cover using the Phillips end of the supplied blade wrench. Remove cover and set aside. Install two AAA batteries according to polarity indicators inside the battery compartment. Replace the battery compartment cover. Reinstall screw and tighten securely. dust bag exhaust port Fig. 11 Base Work Clamp Fig. 12 Laser Switch compartment cover batteries screw Fig. 13 16