Samsung DV45K7600GW/A3 User Manual - Page 21
STEP 4, Connect the water hose applicable models only
View all Samsung DV45K7600GW/A3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Installation STEP 4 Connect the water hose (applicable models only) The dryer must be connected to a cold water tap using the provided water hoses. 1. Close the cold water tap. If you have a washer cold water hose attached to the cold water faucet, unscrew and remove the hose. Then, connect the female end of the Y connector to the cold water tap. 2. Connect the straight end of the water hose to the Y connector. 3. Using pliers, tighten the coupling an additional two-thirds turn. Do not overtighten because the coupling may be damaged. 4. Connect the angled end of the water hose to the filling valve at the bottom of the rear frame. Turn the coupling manually until it is tight. 5. Using pliers, tighten the coupling an additional two-thirds turn. Do not overtighten because the coupling may be damaged. 6. If you detached the cold water hose from your washer, attach the hose to the open end of the Y connector, tighten the coupling until it is tight, and then, using a pliers, tighten an additional two-thirds turn. 7. Open the cold water tap, and then check for any leaks. If the Y connector cannot be directly connected to the cold water tap, use the short hose as shown on the following page. DV7700K-03170U-01_EN (US).indd 21 English 21 2015-12-29 12:08:28