Samsung DVG45T6000W/A3 User Manual - Page 50
after Wrinkle Prevent, Wrinkle Away, Wrinkle
View all Samsung DVG45T6000W/A3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Troubleshooting Problem Action Has odors. • Household odors from paint, varnish, strong cleaners, etc. may enter the dryer with the surrounding room air. This is normal as the dryer draws the air from the room, heats it, pulls it through the tumbler, and exhausts it outside. • When these odors linger in the air, completely ventilate the room before using the dryer. • Use the REFRESH cycle. If odors persist, wash and dry the items again. Lint on clothes. • Make sure the lint filter is cleaned before every load. For clothes that naturally build up lint, clean the filter during the cycle. • Some fabrics are lint producers (for example, a fuzzy white cotton towel) and they must be dried separately from clothes that are lint trappers (for example, a pair of black linen pants). • Divide larger loads into smaller loads for drying. • Check pockets thoroughly before drying, then dry clothes. • Remove lint inside the drum before drying a load. Items still wrinkled after Wrinkle Prevent (Wrinkle Away, Wrinkle Release). • • • Small loads of 1 to 4 items work best. Load fewer items. Load similar-type items. Take out the items immediately after drying is complete. Water drips from the nozzle when the Steam cycles starts. • This is steam condensation. The dripping water will stop after a short time. Sprayed water is not visible during Steam cycles. • Sprayed water is difficult to see when the door is closed. Extended time. • Sensor Dry automatically senses the moisture in the load and shuts the dryer off when the selected dryness level is reached. The drying time can change according to the type and amount of laundry. See the cycle chart for reference. If a problem persists, contact a local Samsung service center. Troubleshooting 50 English Untitled-10 50 2020-07-14 3:22:20