Samsung DVG54R7600V/A3 User Manual - Page 25
STEP 4, Connect the water hose
View all Samsung DVG54R7600V/A3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
WARNING • All U.S. models are designed for a 3-wire system connection. The dryer frame is grounded to the neutral conductor at the terminal block. A 4-wire system connection is required for new or remodeled construction, mobile homes, or if local codes do not permit grounding through neutral. If you use the 4-wire system, you cannot ground the dryer frame to the neutral conductor at the terminal block. • Remove the terminal block cover plate. Insert the power cord with a UL-listed strain relief through the hole provided in the cabinet near the terminal block. • A strain relief must be used. Do not loosen the nuts already installed on the terminal block. Be sure they are tight. Use a 3/8" (1 cm) deep well socket. STEP 4 Connect the water hose The dryer must be connected to a cold water tap using the provided water hoses. 1. Close the cold water tap. If you have a washer's cold water hose attached to the cold water tap, unscrew and remove the hose. Then, connect the female end of the Y-connector to the cold water tap. 2. Connect the straight end of the water hose to the Y-connector. 3. Using pliers, tighten the coupling an additional two-thirds turn. Do not overtighten because the coupling may be damaged. Installation Untitled-18 25 English 25 2020-07-14 3:40:07