Samsung FE-R300SW User Manual (user Manual) (ver.1.0) (English) - Page 17
HOW TO SET THE APPLIANCE FOR SURFACE COOKING, Location of the radiant surface elements and controls
View all Samsung FE-R300SW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Location of the radiant surface elements and controls The radiant control knobs operate the radiant surface elements on the cooktop as shown below. Dual Left Front Element Single Left Rear Element Single Dual Right Rear Right front Element Element 02 SURFACE COOKING Hot surface indicator • Comes on when the unit is turned on or hot to the touch. • Stays on even after the unit is turned off. • Glows until the unit is cooled to approximately 150°F. Cooking areas • The cooking areas on your range are identified by permanent circles on the glass cooking surface. For the most efficient cooking, fit the pan size to the element size. • Pans should not extend more than ½" to 1" beyond the cooking area. • When a control is turned on, a glow can be seen through the glass cooking surface. The element will cycle on and off to maintain the preset heat setting, even at high settings. • For more information on selecting proper types of cookware, refer to the section "Using the proper cookware" on page 18. How to set the appliance for surface cooking • The surface elements may be hot and burns may occur. Do not touch surface elements until they have cooled down sufficiently. • At high or medium-high settings, never leave food unattended. Boilovers cause smoking and greasy spillovers may catch on fire. • Be sure you turn the control knob to OFF when you finish cooking. • The area between the high and off settings, are not appropriate for cooking. Single surface unit control knob (left rear, right rear) 1. Push the knob in. 2. Turn in either direction to the setting you want. • At both the off and high settings, the knob clicks into position. Surface cooking _17