Samsung HC-P5252W Flash Guide (flash Manual) (English) - Page 13

BP68-00289A-00Eng 3/30/04 9:28 AM Page 13 INSTALLATION Connecting to a Cable Box that Descrambles Some Channels If your cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a two-way splitter, an RF (A/B) switch, and four lengths of coaxial cable. (These items are available at most electronics stores.) 1 Find and disconnect the cable that is connected to the ANTENNA IN terminal on your cable box. œ This terminal might be labeled "ANT IN", "VHF IN", or simply "IN". 2 Connect this cable to a twoway splitter. Connect a coaxial cable between an OUTPUT terminal on the splitter and the IN terminal on the cable box. 3 Connect a coaxial cable between the ANTENNA OUT terminal on the cable box and the B-IN terminal on the A/B switch. Incoming Cable Splitter Cable Box RF (A/B) Switch 4 Connect another cable between the other OUT terminal on the splitter and the A-IN terminal on the RF (A/B) switch. 5 Connect the last coaxial cable between the OUT terminal on the RF (A/B) switch and the "ANT 1 IN" terminal on the rear panel. After you've made this connection, set the A/B switch to the "A" position for normal viewing. Set the A/B switch to the "B" position to view scrambled channels. (When you set the A/B switch to "B," you will need to tune your TV to the cable box's output channel, which is usually channel 3 or 4.) 13