Samsung NE63T8111SS/AA Installation Guide - Page 13
Step 5. Replacing the access cover, Installing the range, Installing the anti-tip device
View all Samsung NE63T8111SS/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installing the range Step 5. Replacing the access cover To replace the rear access cover on the range back. Insert the double projections on the bottom of the cover into the pockets located below the opening, and then insert and tighten the rear access cover screw. Installing the anti-tip device WARNING To reduce the risk of tipping, you must secure the appliance by properly installing the Anti-Tip device packed with the appliance. • Refer to the installation instructions supplied with the bracket. • If the anti-tip device is not installed properly, an adult or child stepping on or sitting on the range door could tip the range and suffer serious injuries caused by spilled hot liquids or by the range itself. *approximately 21⁄32" (16.5 mm) Anti-Tip bracket Screw must enter wood or concrete NOTE To install the Anti-Tip bracket, release the leveling leg. A minimum clearance of 21⁄32" (16.5 mm) is required between the range bottom and the kitchen floor. Installing the range Install_NE63T8911_AA_DG68-01257A-00_EN.indd 13 English 13 2020-03-26 6:27:52