Samsung NX58K9850SG/AA Installation Guide - Page 15

Minimum dimensions WARNING If overhead cabinets are provided, a range hood should also be provided that projects horizontally a minimum of 5 in (12.7 cm) beyond the front of the cabinets. This will dissipate any heat buildup in the overhead cabinets to prevent death, personal injury, and/or fire hazard. The ventilating hood must be constructed of sheet metal not less than 0.0122" thick. Install above the cooktop with a clearance of not less than 1/4" between the hood and the underside of the combustible material or metal cabinet. The hood must be at least as wide as the appliance and centered over the appliance. Clearance between the cooking surface and the ventilation hood surface must never be less than 24 inches. Exception 1 : Installation of a listed microwave oven or cooking appliance over the cooktop shall conform to the installations packed with that appliance. • 30-in (76.2-cm) minimum clearance between the top of the cooking surface and the bottom of an unprotected wood or metal cabinet; or If no 30-in (76.2- cm) minimum clearance, 24-in (61-cm) minimum when the bottom of the wood or metal cabinet is protected by not less than 0.25-in (0.64-cm) flame-retardant millboard covered with not less than no. 28 MSG sheet steel, 0.015-in (0.038-cm) stainless steel, 0.024-in (0.061-cm) aluminum, or 0.020-in (0.051-cm) copper. • 18-in (45.7-cm) minimum between the countertop and the adjacent cabinet bottom. Exception 2 : For island installation, maintain 2-1/2" minimum from cutout to back edge of countertop and 4" minimum from cutout to side edges of countertop. IMPORTANT: To eliminate the risk of burns or fire caused by reaching over heated surface units, avoid having cabinet storage space located above the surface units. If you have cabinet storage space over the heating elements, you can reduce the risk by installing a range hood that projects horizontally a minimum of 5 inches beyond the bottom of the cabinets. Installation guide SLIDE-IN CUTOUT Hatched Faces should be flat and leveled. 3" 24" 3" 1"min 35-7/8" 23 3/16" 25" 29 15/16" 36 1/4" A 27 3/4" 1/2"min. FREESTANDING CUTOUT 3" 25" 24" 3" A A: Cabinet opening 30" (76.2) IMPORTANT: If your cabinet have height over 36 1/4", this range cannot be installed wirhout supporting unit like hard block. Recommended locations for gas piping and electrical outlets (For models NX58K9850S*, NX58K9852S*) 17 in x 9 in (43.2 cm x 22.9 cm) Gas Wall Area Recommended area for through-the-wall and through-the-floor connection of gas pipe stub and shut-off valve. Recommended position 12 in (30.5 cm) Recommended area for 120 V electrical outlet on rear wall 17(4Gi3na.2sxFc2mloion3xr0C5Aai.brn1ein(ac7me6t).O2pcemn)ing English 15 Installation requirements