Samsung NX58M6850SS/AA Installation Guide - Page 21
risk of electric shock., in this manual. Improper connection of the grounding plug can result in - review
View all Samsung NX58M6850SS/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
*apporoximately 5/8 (16. mm) Anti-Tip bracket Screw must enter wood or concrete *NOTE: To install the AntiTip bracket, release the leveling leg. A minimum clearance of 5/8" (16 mm) is required between the range bottom and the kitchen floor. To check if the bracket is installed and engaged properly, remove storage drawer and look underneath the range to see that the leveling leg is engaged in the bracket. Carefully tip the range forward. The bracket should stop the range within 4 inches (10.2 cm) of tipping. If it does not, the bracket must be reinstalled. If the range is pulled from the wall for any reason, always repeat this procedure to verify the range is properly secured by the anti-tip bracket. Never completely remove the leveling legs or the range will not be secured to the anti-tip device properly. Step 5. Plug in and place WARNING BEFORE OPERATING OR TESTING, follow the grounding requirements on pages 20 ~ 22 in this manual. Improper connection of the grounding plug can result in a risk of electric shock. • All gas ranges come with a power cord. The power cord is connected to the rear of the range. Please review "Electrical requirements" on pages 20 ~ 22. • All U.S. and Canadian models are produced with a 3-wire, 120-volt, 60-Hertz electrical system. The entire system, including the power cord, is preinstalled and prewired Gas Range Plug 1. Plug in the power cord. Make sure the outlet meets local or national electrical codes as referenced on pages 20 ~ 22. 2. Slide the range into place. 3. Check the gas supply line to make sure it did not get damaged and it stayed connected during positioning. 4. Check to make sure the back leg of the range has slid into the anti-tip bracket. Carefully tip the range forward to ensure that the anti-tip bracket engages the back brace and prevents tip-over. Installation instructions Install_NX58M6850SS_DG68-00910A-02_EN+MES+CFR.indb 21 English 21 2017-12-13 5:21:56