Samsung NX58M6850SS/AA Installation Guide - Page 25
Adjusting the oven burner air adjustment shutters, English 25
View all Samsung NX58M6850SS/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Adjusting the oven burner air adjustment shutters Air adjustment shutter All oven burners have an air adjustment shutter. The purpose of the shutter is to regulate the flow of air to the flames. Properly adjusted flames should burn steadily with approximately 1-in of blue cone. The flames should never extend past the edge of the burner baffles. Even though these are preset at the factory, they should be checked and, if needed, adjusted periodically to ensure efficient operation. Locking screw To check and adjust the oven burner air adjustment shutters: 1. Open the oven door. 2. Remove the oven racks. 3. Remove the oven floor. 4. Press the Bake pad, then the START pad. 5. After the oven has lit, visually check the flames coming out of the upper and lower burners. If adjustment is needed, carefully adjust the air adjustment shutters. Locking screw The shutters are located at the base of the burner manifolds near the back oven wall. To adjust the shutter, loosen the locking screw and rotate the shutter towards the open or closed position as needed. If flames are lifting off the burner ports, gradually reduce the air shutter opening until the flames are stabilized. If flames are too yellow and/or too large, gradually increase the air shutter opening until the flames have approximately a 1-in blue cone. NOTE If the range is set up for natural gas, the flames should burn with no yellow tipping. If the range is set up for LP gas, small yellow tips at the end of the cones are normal. After the flames are adjusted properly, shut off the oven, retighten the locking screws, replace the oven bottom and racks, and close the oven door. Installation instructions Install_NX58M6850SS_DG68-00910A-02_EN+MES+CFR.indb 25 English 25 2017-12-13 5:21:58