Samsung RF25HMEDBSG User Manual - Page 24

Using The Ice Off, Function

Page 24 highlights

If There is a Power Failure If a power failure occurs, ice cubes may melt then freeze together when the power comes back on, causing the dispenser to be out of order. To prevent this problem, after a power failure, pull out the ice bucket and discard the residual ice or water. After you dump the ice from the ice bucket, you should press the dispenser lever once with the 'Water' or 'Ice Type' function ON. The ice maker will make new ice faster after you return the ice bucket to the refrigerator. CAUTION • Use only the ice maker provided with the refrigerator. The water supply to this refrigerator must only be installed/connected by a suitably qualified person. Connect to a potable water supply only. • To operate the ice maker properly, water pressure of 20 ~ 125 psi is required. If you use all the ice at once, you must repeat Steps 2 and 3 on the previous page. However, only wait 8 hours before dispensing the first 4 to 6 ice cubes. This will replenish the ice cubes and ensure maximum ice production. Going on vacation... If you are going on a long vacation or business trip and won't use the water or ice dispensers for a long time: - Close the water valve. Otherwise, water leakage may occur. - Remove all food and ice in the ice bucket. - Unplug the refrigerator. - Wipe excess moisture from inside and leave the doors open. Otherwise, odor and mold may develop. USING THE ICE OFF FUNCTION When you select the Ice Off mode, remove all ice cubes from the bucket. If you leave the ice cubes in the bucket, the ice cubes may clump together, making it difficult to remove them. To remove the ice bucket safely and avoid injury, hold the bottom of the bucket with one hand and the side of the bucket with the other. Then, lift up on the ice bucket, and pull it straight out. To put the ice bucket back in, push it firmly straight back. If the ice bucket is not pushed firmly into place, ice in the bucket can melt. If the bucket does not fit, turn the helix 90 degree (see the last illustration on the right, below) and try again. Ice Maker Do's and Don'ts • Do not put your fingers, hands or any other unsuitable objects in the chute or ice-maker bucket - It may result in personal injury or material damage. • Never put your finger or any other objects in the dispenser opening. - It may cause injury. • Do not try to disassemble the ice maker. • Do not wash or spray the ice bucket with water while it is in the refrigerator. Remove it to clean it CAUTION When you insert the Ice maker tray, be sure that the tray is well centered at the entrance. Otherwise, the tray may get stuck. English - 24 DA68-02601G-00.indb 24 2014. 12. 4. �� 3:05

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116

English - 24
If There is a Power Failure
If a power failure occurs, ice cubes may melt then
freeze together when the power comes back on,
causing the dispenser to be out of order.
To prevent this problem, after a power failure, pull
out the ice bucket and discard the residual ice or
water.
After you dump the ice from the ice bucket, you
should press the dispenser lever once with the
‘Water’ or ‘Ice Type’ function ON. The ice maker
will make new ice faster after you return the ice
bucket to the refrigerator.
If you use all the ice at once, you must
repeat Steps 2 and 3 on the previous
page. However, only wait 8 hours before
dispensing the first 4 to 6 ice cubes. This
will replenish the ice cubes and ensure
maximum ice production.
USING THE ICE OFF
FUNCTION
When you select the Ice Off mode, remove all ice
cubes from the bucket. If you leave the ice cubes
in the bucket, the ice cubes may clump together,
making it difficult to remove them. To remove
the ice bucket safely and avoid injury, hold the
bottom of the bucket with one hand and the side
of the bucket with the other. Then, lift up on the
ice bucket, and pull it straight out. To put the ice
bucket back in, push it firmly straight back.
If the ice bucket is not pushed firmly into
place, ice in the bucket can melt.
If the bucket does not fit, turn the helix 90 degree
(see the last illustration on the right, below) and try
again.
CAUTION
Use only the ice maker provided with
the refrigerator. The water supply to this
refrigerator must only be installed/connected
by a suitably qualified person. Connect to a
potable water supply only.
To operate the ice maker properly, water
pressure of 20 ~ 125 psi is required.
Going on vacation...
If you are going on a long vacation or business
trip and won’t use the water or ice dispensers for
a long time:
-
Close the water valve. Otherwise, water
leakage may occur.
-
Remove all food and ice in the ice bucket.
-
Unplug the refrigerator.
-
Wipe excess moisture from inside and leave
the doors open. Otherwise, odor and mold
may develop.
Ice Maker Do’s and Don’ts
Do not put your fingers, hands or any other
unsuitable objects in the chute or ice-maker
bucket
-
It may result in personal injury or material
damage.
Never put your finger or any other objects in
the dispenser opening.
-
It may cause injury.
Do not try to disassemble the ice maker.
Do not wash or spray the ice bucket with
water while it is in the refrigerator. Remove it
to clean it
CAUTION
When you insert the Ice maker tray, be sure that
the tray is well centered at the entrance.
Otherwise, the tray may get stuck.
DA68-02601G-00.indb
24
2014. 12. 4.
�� 3:05