Samsung RS2630WW Quick Guide (easy Manual) (ver.1.0) (English) - Page 25

INSTALLATION OF THE WATER DISPENSER LINE 3) Remove the protective cap, then position and insert the filter as shown. 4) Slowly turn the water filter clockwise 90º to align the indication mark on the cover, locking the filter in position. SEPARATION OF RED CAP COVER FILTER ALIGN THE INDICATION MARK WITH LOCK POSITION. STICKER (MONTH INDICATION) NOTE • Please check that the indication line aligns with the lock position. • If you are replacing the cartridge, first remove the old one by slowly turning it to the left. Do not pull down on the cartridge. A small amount of water may drip down. • If your refrigerator does not have a water filter, we recommend installing one if your water supply has sand or particles that could clog the screen of the refrigerator's water valve. Install it in the water line near the refrigerator. Remove any residual matter inside the water supply line after installing filter. 1) Turn on the main water supply & shut-off valve of the water supply line. 2) Run water through the dispenser until the water runs clear (6~7 minutes). This will clean the water supply system and clear air from the lines. 3) Additional flushing may be required in some households. 4) Open the refrigerator door and check if water leaks around the water filter. ICE WATER INSTALLATION INSTRUCTIONS • A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser. NOTE 25