Samsung SHR-6042 User Manual - Page 27

05 menu setup  Search The "Playback" item allows granting the search right. Profile Profile Load Factory Default OK Profile Export OK Profile Import OK Progress trying.. 0% OK Move/Control Select Exit  Load Factory Default This function is used when you reset all menu setting values to the factory default values. If you press "OK", the restart message window appears. You can select "Yes". The recorded data will not be deleted.  Profile Export Allows you to configure multiple DVR units with ease. This function is used when you export the profile currently set to the system to the storage device connected to a USB port. The profile file will be copied to the USB memory if you press "OK". (Filename: SetupData.tar)  Profile Import This function is used when you import the system profile file stored in a USB memory and apply to the current system. The profile file will be copied to the current system if you press "OK". Then, the restart message window appears. You can select "Yes".  Progress This function will show the progress status of the job that the system is currently executing.  Please do not remove the USB memory when you run the profile export/import Caution function. The system profile file may not be copied properly or may not be applied to the system.  When the system profile file that is included the value for network setup applies for another DVR, an IP address conflict may occur due to the same address. If so, please reset the network configuration to avoid an IP address conflict. System Log System Log 04-02 06:08:09 C3 C REC Stop 04-02 06:08:09 C3 M REC Start C3 04-02 06:08:47 C2 M REC Stop 04-02 06:08:47 C1 M REC Stop 04-02 06:08:50 C4 M REC Stop 04-02 06:08:50 C3 M REC Stop 2007-04-02 05:39:53 ž 2007-04-03 05:39:53 REC System Failure Search Network Backup OK This function shows a series of logged tasks made in operating the DVR system and when the system runs abnormally, it allows finding the error easily so that the problem can be fixed. Press the Enter( ) button after moving the cursor on the desired log item. ( ): Move to the previous page. ( ): Move to the next page.  Scope Designation If the ( ) icon is pressed, the following screen appears. Start Time 2007 - 04 - 02 05 : 39 : 53 Year Month Day 2007 4 2 Hour Min Sec 5 39 53 End Time 2007 - 04 - 03 16 : 35 : 44 Year Month Day 2007 4 3 Hour Min Sec 16 35 44 OK For the log data, set the "Start Time" and "End Time " to be searched. To change the date and time, move the cursor to the corresponding item and press the Enter( ) button. Then, change the day/month/year or second/minute/hour using the  or  buttons. Escape from the change mode by pressing the Enter ( ) button again. menu setup _23