Samsung WF405ATPASU/AA Trouble Shooting Guide User Manual Ver.1.0 (English, Fr - Page 2

Alignment And Adjustments - when did the come out

Get Samsung WF405ATPASU/AA PDF manuals and user guides View all Samsung WF405ATPASU/AA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. GENERAL ERROR FUNCTION NO Error Code Diagnostic Code Error Image Description Corrective Action 1 nd nd The water level fails to drop below the Reset Water Level within 15 minutes. Go to " Will Not Drain" Troubleshooting Section. 2 LO LO Door fails to Unlock After 7 attempts. Go to " Will Not Unlock" Troubleshooting Section. 3 nF nF When the filling Continues for more than 40 minutes or there is no change of water level for 6 minutes. Go to " No Water Fill" Troubleshooting Section. 4 FL 5 LE 6 LE(1E) 7 OE 8 dc 9 E2 10 ds FL LE LE(1E) OE dc E2 ds Door fails to lock after 7 attempts. Go to " Will Not Lock" Troubleshooting Section. A water level lower than the Reset water level (25.6Khz) is detected for Go to "No Water Fill" 5 seconds during the Wash/Rinse Troubleshooting Section. cycle. Water Level Sensor Trouble. (When the input signal from the water level sensor is out of range, the unit will send out beeping sounds and halts Go to "No Water Fill" Troubleshooting Section the cycle.) A fault is detected in the water level sensor. Data (frequency) shows the water level is at or above the overflow water level. (When this condition is detected, the machine will automatically starts draining First check to see that all of water valves are not stuck. If water valves are OK, check water level sensor. water until the water level falls below the overflow water level) Unbalance or cabinet bump is detected during final spin, which prevents the drum from spinning over 140 rpm. (Never exceeds 150 RPM due to unbalanced load) Go to "Wet Clothes" Troubleshooting Section. Jammed Key.(When key input signals are coming out for more than 30 seconds, it is regarded as a jam.) Check all of keys. If A key is sensed to be pressed, all keys will do not respond. Door is detected as open while it is Go to "Quick Test Mode" and then trying to lock the door. do Door Lock/Unlock Test 2 WF405ATP-03144A_EN.indd 2 2012-03-02 �� 9:28:47

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
ALIGNMENT AND ADJUSTMENTS
2
GENERAL ERROR FUNCTION
NO
Error
Code
Diagnostic Code
Error Image
Description
Corrective Action
1
nd
nd
The water level fails to drop below
the Reset Water Level within 15
minutes.
Go to “ Will Not Drain”
Troubleshooting Section.
2
LO
LO
Door fails to Unlock After 7
attempts.
Go to “ Will Not Unlock”
Troubleshooting Section.
3
nF
nF
When the filling Continues for
more than 40 minutes or there is no
change of water level for 6 minutes.
Go to “ No Water Fill”
Troubleshooting Section.
4
FL
FL
Door fails to lock after 7 attempts.
Go to “ Will Not Lock”
Troubleshooting Section.
5
LE
LE
A water level lower than the Reset
water level (25.6Khz) is detected for
5 seconds during the Wash/Rinse
cycle.
Go to “No Water Fill”
Troubleshooting Section.
6
LE(1E)
LE(1E)
Water Level Sensor Trouble. (When
the input signal from the water level
sensor is out of range, the unit will
send out beeping sounds and halts
the cycle.)
Go to “No Water Fill”
Troubleshooting Section
7
OE
OE
A fault is detected in the water level
sensor. Data (frequency) shows
the water level is at or above the
overflow water level. (When this
condition is detected, the machine
will automatically starts draining
water until the water level falls
below the overflow water level)
First check to see that all of water
valves are not stuck. If water valves
are OK, check water level sensor.
8
dc
dc
Unbalance or cabinet bump is
detected during final spin, which
prevents the drum from spinning
over 140 rpm. (Never exceeds 150
RPM due to unbalanced load)
Go to “Wet Clothes”
Troubleshooting Section.
9
E2
E2
Jammed Key.(When key input
signals are coming out for more
than 30 seconds, it is regarded as
a jam.)
Check all of keys. If A key is sensed
to be pressed, all keys will do not
respond.
10
ds
ds
Door is detected as open while it is
trying to lock the door.
Go to “Quick Test Mode” and then
do Door Lock/Unlock Test
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
WARNING
WF405ATP-03144A_EN.indd
2
2012-03-02
�� 9:28:47