Sanyo CE42LM4WPN-NA Owner's manual - Page 4
Step : 1, Connections, Essential - rs232
UPC - 086483065156
View all Sanyo CE42LM4WPN-NA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTALLATION Step : 1 Connections (Essential) ■ REMOVE TERMINAL COVER AS INDICATED BELOW. 1.■ HDMI (High Definition Multimedia Interface) This monitor has an HDMI connector. When connected to the HDMI source and HDMI is selected using the remote control, there is a short time period before the picture appears at a much higher resolution. This connection is located at the back of the monitor next to the aerial socket. Security Fixing point PJ-Net Cable entry Cable entry ■ CONNECT THE DISPLAY UNIT TO VGA. BNC.AND PERITEL SCART CONNECTOR AS BELOW. ■ TERMINAL COVER MUST BE REPLACED WITH CABLE EXITS AS INDICATED IN THE SKETCH ABOVE. PJ Net box Security fixing point Wall mount fixing positions Switch HDMI Services AV3 IN/Out BNC AV2 IN/ Out BNC AV2 audio IN Audio monitor Out RS232C Serial ports IN/ Out In-line connector ■ Connect the LCD monitor to VGA, and Scart connector as required. 1. Connect the in-line power connector to the connector attached to the LCD monitor as shown above. 2. Connect the correct power cord of the LCD monitor to a wall outlet. 2. Y,Pb,Pr connection (AV2) This LCD monitor has a choice of Y, Pb, Pr or RGB , H/V connections You can connect your DVD player to the Y, Pb, Pr terminals instead of using a scart lead. This can support high definition in analogue component form. RGB, H/V can be used as a PC input via the BNC terminal. Serial port PJ-net Service Serial Port-IN Peritel (Scart) Serial Port-OUT 3. PC connection This display unit has a PC connector. You can connect a PC to the Display unit and use it as a monitor (see page 7). To switch between AV1, RGB, AV2 RGB H/V or Y, Pb, Pr, AV3, HDMI or PC mode press the TV/AV switch on your remote control repeatedly or press and hold the the TV/AV button for a few seconds and selection menu will appear on screen use the e or d buttons to select the correct mode. 4. RS232C IN/OUT: Is an input for external commands to control the monitor (see page 8). Use the switch to change between RS232/ PJ net 5. PJ Net IN/OUT: Has the ability for PJ-NET to be connected to control the monitor using a network. Step : 2 Remote control battery installation ✐ As this product does not have a power On/Off switch, please ensure your mains plug is easily accessible. ✐ The LCD monitor is prepared for a power voltage AC100 ~240V, 60Hz. To completely switch off the mains, or when the LCD monitor is not to be used for an extended period of time, it is advisable to disconnect the power cord from the power outlet or disconnect the power coupler. 3. Warning: To prevent injury, the unit must be securely attached to the wall in accordance with the installation instructions. WARNING! High voltages are used in the operation of this set. Refer service to qualified service personnel. 4 Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the batteries match the "+" and "-" marks inside the unit into the remote control handset.