Sanyo DVD-SL33 Instruction Manual - Page 14

Connecting to an Amplifier with Dolby Pro Logic Decoder (Example 6) To AUDIO INPUT jacks Amplifier with Dolby Pro Logic Decoder *Audio cable (not supplied) To AUDIO OUT jacks Center speaker Front left speaker Surround left speaker Front right speaker Subwoofer Surround right speaker Note: Please refer to your amplifier instruction manual. Power Supply Connect the power cord to a 120VAC 60Hz outlet. This unit is equipped with a polarized plug. If you have difficulty inserting the plug, turn it over and reinsert it. If the unit will not be used for a long time, disconnect the AC plug from AC outlet. Notes: • Before plugging the power cord into an AC outlet, make sure that all the connections have been made. • The unit is not disconnected from the AC power unless the power cord is unplugged from the AC outlet. *Please consult your local audio/video dealer. CAUTION: When connecting the DVD video player, follow the installation instruction in "IMPORTANT SAFETY INSTRUCTIONS" on page E2. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'AU FOND. FOR SAFE AND EFFICIENT OPERATION • Do not damage the power cord. • When not in use, disconnect the power cord from the outlet. Grasp the plug, not the cord, when disconnecting the unit. • If water should enter the unit, electrical shock or a malfunc- tion may result. Use in an area where there is low humidity and little dust. • Do not disassemble or alter the unit in any way. • Do not use the unit in areas where extremes in temperature occur (below 40˚F(5˚C) or exceeding 95˚F(35˚C)), or where it may be exposed to direct sunlight. • Because of the DVD video player extremely low noise and wide dynamic range, there is a tendency to set the volume on the amplifier higher than necessary. Doing so may produce an excessively high output from the amplifier which can cause damage to your speakers. Please be careful in this regard. • Sudden changes in the surrounding temperature can cause dew to form on the optical pickup lens inside the unit. Under this condition the unit may be unable to operate properly. If this should occur, remove the disc and allow the player to adjust to the surrounding temperature. • When carrying the unit, be sure to remove a disc which may be inside and turn the power off. Then unplug the power cord from the AC outlet after 10 seconds. Carrying the unit with a disc inside may damage the disc and/ or the unit. • The unit is automatically set to the Screen Saver mode after approximately 15 minutes have elapsed under the stop or pause mode. • The unit is automatically set to the standby mode after approximately 30 minutes have elapsed under the complete stop mode. • Do not install this equipment in confined space, such as a book case or built in cabinet. Press [ q ] (or [OPEN/CLOSE] on the remote control) when closing the disc tray. Do not push the disc tray. -E13- DVD-SL33/CA(English) 14 13/06/2003, 10:06