Sanyo PLC-HP7000L RS232C Expand - Page 10
Overview, Serial Interface Specification, Transfer Specification, Connection, Projector, COM 1,
View all Sanyo PLC-HP7000L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
PLC-HP7000L Expand Serial Command Functional Specifications 1 Overview ・ This Functional Specification defines communication with PJ-Net organizer for PLC-HP7000L. ・ Supporting Firmware Ver. 1.x of the projector. ・ Commands in this document are to communicate with PJ-Net organizer, but most commands are used to control a projector remotely from a computer with RS-232C. Therefore commands in this document are defined as Expand Serial Commands. 2 Serial Interface Specification 2.1 Transfer Specification Item Specification Synchronous System Asynchronous Transmission Speed Data Length Parity Stop Bit Flow Control 9600 / 19200 8 bits N/A 1 N/A Note1) Transmission Speed: initial setting value is 19200 Note2) Transmission Speed can be changed in Service mode. 2.2 Connection Dedicated serial cables must be used for the connection between a computer and a projector. PC Projector COM 1 CONTROL PORT (D-Sub 9Pin) (D-Sub 9Pin) Connect COM port of the computer to CONTROL PORT of the projector. COM Port (COM1 or COM2) of a computer is specified by control software of the computer. 10/94