Sanyo PLV Z2 Owners Manual - Page 14

Installation Positioning the Projector This projector is designed to project on a flat projection surface and can be focused from 3.9'(1.2m) - 20.0'(6.1m). Refer to the figure and the table below for the screen size and the distance between the projector and the screen. 20.0' (6.1m) 15.1' (4.6m) 9.8' (3.0m) 3.9' (1.2m) 100" 40" 76" 150" 116" 200" (Inch Diagonal) Zoom (max) 154" Zoom (min) 31" Screen Size (W x H) mm 16 : 9 aspect ratio Zoom (min) Zoom (max) 31" 686 x 386 3.9' (1.2m) ----- 40" 884 x 497 5.2' (1.6m) 3.9' (1.2m) 100" 2209 x 1244 13.1' (4.0m) 9.8' (3.0m) NOTE G The brightness in a room has a great influence on picture quality. It is recommended to limit ambient lighting in order to provide the best image. G The values shown are approximate and may vary from the actual size. 150" 3314 x 1866 19.3' (5.9m) 15.1' (4.6m) (Center) 200" 4419 x 2489 ----- 20.0' (6.1m) Adjustable Feet Projection angle can be adjusted up to 11.8 degrees with the adjustable feet. 1 Lift the front of the projector and pull the feet lock latches on both sides of the projector. 2 Release the feet lock latches to lock the adjustable feet and rotate the adjustable feet to adjust the position and tilt. 3 To retract the adjustable feet, lift the front of the projector and pull and undo the feet lock latches. Keystone distortion of the projected image can be adjusted by menu operation. (p20, 39) CAUTION Tilt the projector within the adjustable range in order not to shorten the life of the lamp. Proper angle should be taken. See page 5. 14 Adjustable Feet Feet Lock Latches