Schwinn 420 Elliptical 2012 model Assembly and Owner's Manual
Schwinn 420 Elliptical 2012 model Manual
View all Schwinn 420 Elliptical 2012 model manuals
Add to My Manuals
Save this manual to your list of manuals |
Schwinn 420 Elliptical 2012 model manual content summary:
- Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 1
Manual en Español Latino Americano: http://www.schwinnfitness.com ASSEMBLY MANUAL / OWNER'S MANUAL - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 2
33 Troubleshooting 35 To validate warranty support, keep the original proof of purchase and record the following information: Serial Number Date of Purchase To register your product warranty , go to: www.SchwinnFitness.com/register Or call 1 (800) 605-3369. If you have questions or problems - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 3
connect power supply to the machine until instructed to do so. • Do not service until the machine has been fully assembled and inspected for correct performance in accordance with the Manual. • Read and understand the complete Manual supplied with this machine before first use. Keep the Manual - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 4
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 5
Using the recommended wrenches, turn the bolts and nuts to the right (clockwise) to tighten, and the left (counterclockwise) to loosen, unless instructed otherwise. 4. When attaching 2 pieces, lightly lift and look through the bolt holes to help insert the bolt through the holes. 5. The assembly - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 6
1 Lower Right Handlebar Arm 16 1 Static Handlebar 17 1 Console 18 1 Mast Boot 19 1 AC Adapter 20 1 Arm Pivot Rod 21 1 Water Bottle Holder 22 1 Media Support - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 7
HARDWARE / TOOLS A B C D E F G H I J K L M N O Item Qty Description A 4 Wide Flat Washer M8 B 41 Lock Washer M8 C 41 Flat Washer M8 D 4 Hex Head Bolt M8 x 20 E 2 Button Head Hex Screw M8 x 25 Thread Lock F 4 Lock Washer, Black M8 G 20 Button Head Hex Screw M8 x 20 H 2 Button Head Hex - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 8
ASSEMBLY 1. Attach Rear Stabilizer and Transport Handle to Rails 3 7 6 7 X2 J K 2. Attach Rail Assembly and Front Stabilizer to Frame 1 X8 CB I 6 mm X8 6 mm G B C 4 8 - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 9
3. Attach Console Mast to Frame Assembly NOTICE: A lign the clips on the cable connectors and make sure the connectors lock. Do not crimp the Console Cable. 5 X5 C B I 18 6 mm 9 - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 10
4. Attach the Static Handlebar NOTICE: Do not crimp the Console Cable. 16 X4 C B G 6 mm 10 - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 11
5. Connect the Console Note: Remove the pre-installed screws from the back of the console before you connect the cables. 17 11 - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 12
6. Attach Console to Frame Assembly NOTICE: Do not crimp the cables. Note: Use the screws from Step 5 to attach the console. To install the Media Support, slide it into the holes at the top of the console. 17 X4 22 17 6 mm 12 - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 13
7. Attach Legs to Frame Assembly 11 8. Attach Lower Handlebar Arms X2 N 14 X2 AF D L 10 X2 20 AF D L 15 13 - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 14
9. Attach Pedals to Rails and Lower Handlebar Arms NOTICE: Be sure the key on the Cotter Pin engages the Lower Handlebar Arm. X2 C B C I B C H B I 6 mm 9 2 X2 M C B E 6 mm 2 8 14 - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 15
10. Attach Upper Handlebar Arms 13 X8 12 C B G 6 mm 15 - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 16
11. Install Water Bottle Holder X2 21 O 6 mm 16 - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 17
fasteners are tight and components are properly assembled. Be sure to record the serial number in the field provided at the front of this manual. ! Do not use or put the machine into service until the machine has been fully assembled and inspected for correct performance in accordance with the Owner - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 18
BEFORE YOU START Leveling the Machine If your workout area is uneven, you must level your machine. Turn the leveling bolts (A) below the stabilizers and rails until the machine is level. ! Do not adjust the levelers to such a height that they detach or unscrew from the machine. Injury to you or - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 19
IMPORTANT SAFETY INSTRUCTIONS ! This icon means a potentially hazardous situation which, if not avoided, could result in death or serious injury. Before using this equipment, obey the following warnings: ! Read and understand the complete Manual. Keep the Manual for future reference. Read and - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 20
Features N M I L K J H A Console B Handlebar Arms C Static Handlebar D Water Bottle Holder E Main Frame Assembly F AC Adapter Plug G Transport Wheels A B C D E F G I H I H Stabilizer Bars I Levelers J Rails K Rollers L Pedals M Transport Handle M Contact Heart Rate (CHR) sensors 20 - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 21
resistance levels while you exercise. The Console has a grid display with touch control buttons to navigate you through the exercise programs. Media support Fan Fan button Quick Start Stop Media tray Increase button Start / Enter Speakers Decrease button MP3 input MP3 / Smart phone holder Keypad - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 22
km) in the workout. Note: To change the measurement units to English Imperial or metric, refer to the "Console Setup Mode" section in this manual. RPM / KCAL (Calories) The RPM/KCAL display field shows the machine revolutions per minute (RPM) for 6 seconds, then the KCAL display shows the estimated - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 23
comfortably around the sensors. Be sure that your hands touch both the top and the bottom of the sensors. Hold firm, but not too tight usually linear, decreasing by approximately one BPM for each year. There is no indication that training influences the decrease in maximum heart rate. Individuals - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 24
typical adult has an at rest heart rate of approximately 72 BPM, where as highly trained runners may have readings of 40 BPM or lower. The Heart Rate table is an estimate of what Heart Rate Zone (HRZ) is effective to - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 25
Lb" (English units) and "Km-Kg" (metric units) . 2. Push START/ENTER to set. 3. The Console display shows Select Elliptical or Bike prompt. Push the Increase/Decrease buttons to go to the ELLIPTICAL option. 4. Push START/ENTER to set. The Console goes back to the Power-Up Mode screen. To change - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 26
to save your workout data, refer to the User Setup procedure in this manual. If you select the User profile option, you have two options: data. The Workout option goes to the Program Menu. User Setup Mode The Schwinn® 20 Series console lets you store and use 1 User profile in addition to - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 27
From the Power-Up Mode screen, push START/ENTER and hold for 3 seconds to go to User Setup Mode. If no User profile is set up, you can add a User. If there is a User profile, you can edit or delete the User profile. Note: Push the STOP button to go back to the previous screen or character. Add User - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 28
To exit the Edit option, push STOP and the console will go back to the Edit and Delete options. 2. After you start the Edit function, the Console will show the Name prompt. To edit the name, push START/ENTER. Note: Use the Increase/Decrease buttons to move through the alphabet. To record each - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 29
Profile Programs These programs automate different resistances and workout levels. Course 1 Course 2 Circuit 1 Circuit 2 Pursuit 1 Pursuit 2 To start a Profile Program: 1. Step onto the machine. Push START/ENTER and start to pedal. 2. Use the Increase() or Decrease() buttons to - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 30
value for 4 seconds: TIME, DISTANCE, CALORIES, AVG/MPH (KMH), AVG/HR, MAX HR. You can use the START/ENTER button to move through the results manually. The HR display shows the current BPM value. The Level during Cool Down is based on the Level at the end of the workout: End - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 31
the Totals option, after a few seconds the workout statistics start to scroll automatically. You can use the Increase/Decrease buttons to move through the results manually. Push STOP to exit to the User Statistics menu. If you go to the Reset Totals option, the Console display shows a Reset Stats - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 32
type, or see maintenance statistics (Error Log and Run Hours - for service technician use only). 1. Hold down the Increase button and Decrease button start Machine Type option. Push the Increase/Decrease buttons to change between ELLIPTICAL and BIKE. 5. Push START/ENTER to set. 6. The Console - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 33
MAINTENANCE Read all maintenance instructions fully before you start any repair work. In some conditions, an assistant is necessary to do the necessary tasks. ! Equipment must be regularly examined for - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 34
Maintenance Parts A DD V B X BB W Y ZD CC C AA U K T RQ H J M E F P S K NO I G L H N J N A Console K B Console Mast L C Water Bottle Holder M D Upper Right Handlebar Arm N E Lower Right Handlebar Arm O F Crank, Right P G Pedal Arm, Right Q H Pedal R I Leg, Right S - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 35
Troubleshooting Condition/Problem No display/partial display/ unit will not turn on Unit display and all connections are fine, replace the Console. If the above steps do not resolve the problem, contact Customer Care for further assistance. Be sure cable is connected securely to Console. Be sure - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 36
Static Handlebar Console displays "E2" error Check data cable integrity code Check data cable connections/orientation Console Electronics No speed/RPM reading, or Check data cable integrity Console displays "E3" error code Check data cable connections/orientation Check magnet position (requires - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 37
off Unit rocks/does not sit level Resistance does not change Drive train click/tick noise once per full crank revolution Squeaking noise that appears lower handlebars. Check foot assemblies, leg assemblies, handlebar assemblies Manually move foot, leg, and handlebar assemblies to isolate sound. - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 38
This page intentionally left blank. 38 - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 39
This page intentionally left blank. 39 - Schwinn 420 Elliptical 2012 model | Assembly and Owner's Manual - Page 40
Nautilus® 004-4616.080511.C Bowflex® Schwinn® Fitness Universal®
ASSEMBLY MANUAL / OWNER’S MANUAL
Manual en Español Latino Americano:
http://www.schwinnfitness.com