Schwinn 420 Elliptical 2012 model Assembly and Owner's Manual - Page 37

Fan (if equipped) will not turn on or will not turn off Unit rocks/does not sit level Resistance does not change Drive train click/tick noise once per full crank revolution Squeaking noise that appears a few minutes into a workout and normally will get progressively worse as the workout continues Check RPM Sensor (requires shroud removal) RPM sensor should be aligned with magnet and connected to data cable. Re-align sensor if necessary, replace if any damage to sensor or connecting wire. Check data cable integrity All wires in cable should be intact. If any are cut or crimped, replace cable. Check data cable connections/orientation Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Reset machine Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. Check leveler adjustment Leveling feet may be turned in or out to level the machine. Check surface under unit Adjustment may not be able to compensate for extremely uneven surfaces. Move the machine to level area. Check that unit powers up If machine powers up and otherwise functions normally, contact Customer Care for assistance. Check crank/pulley assembly Disconnect left and right foot assemblies and rotate crank. If sound persists, replace crank/pulley assembly. If sound does not come from rotating crank, check foot assemblies and upper/lower handlebars. Check foot assemblies, leg assemblies, handlebar assemblies Manually move foot, leg, and handlebar assemblies to isolate sound. Replace part making sound. Bolt that connects the Loosen pivot rod bolt slightly until noise swing arms to the axle run- goes away. See video for demonstra- ning through the console tion. White lithium grease can also be mast applied for a temporary fix. Contact Customer Care for assistance. 37