Sharp AR-M280 AR-M280 AR-M350 AR-M450 Operation Manual (for copier) - Page 14

NORMAL COPYING Copying from the document glass When copying originals which cannot be fed from the automatic document feeder such as thick originals, open the document cover and copy the originals from the document glass I 1-sided copies of 1-sided originals Original Copy 1 Set an original on the document glass. (page 7) Original size detector Original scale mark Original scale mark 51/2 x 81/2 or A5 81/2 x11 or A4 81/2 x14 or B4 11x17 or A3 81/2 x11R or A4R G Set an original by aligning its corner with the tip of the scale ( ) mark at the left rear corner of the glass as shown in the illustrations. 2 Ensure that the 1-sided to 1-sided copy mode is selected. ORIGINAL 81/2x11 The one-sided to onesided mode is selected 81/2x11 1. 81/2x11 2. 81/2x11 3. 11x17 4.81/2x11R when no icon for a twosided mode appears in the dashed area on the display. If the 1-sided to 1-sided copy mode is already selected steps 3 to 5 are not needed. 3 Ensure that paper of the same size as the original is automatically selected. (✼Note) The selected tray will be AUTO 8 11 1/2X PAPER SELECT highlighted or the message "LOAD xxxxxx PAPER." will appear. If the message appears, load paper in a 100% paper tray or the bypass tray with paper of the required COPY RATIO size. Even if the message above is displayed, copying can be performed onto the currently selected paper. (✼Note) The following conditions must be satisfied. G Originals of a standard size (11" x 17", 8-1/2" x 14", 8-1/2" x 11", 8-1/2" x 11"R, 5-1/2" x 8-1/2", A3, B4, A4, A4R or A5) are set and the auto paper select function is enabled. If originals of a size other 1. 8 11 1/2X PLAIN than the sizes above are to be copied, manually select 2. 8 11 1/2X TRANSPA the desired paper size. 3. 11x17 PLAIN 12