Sharp LC-37D4U LC-26GD4U LC-32GD4U LC-37GD4U Operation Manual - Page 20
Notice
UPC - 074000363014
View all Sharp LC-37D4U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Watching TV C. Connecting Antenna Cable with VCR Coaxial Antenna Cable (commercially available) signal splitter (commercially available) Cable lead-in RF Cable (Supplied) Audio Cable (commercially available) Video Cable (commercially available) VIDEO AUDIO OUT IN NOTE VCR • Be sure to remember what kind of connection is made with your System. • Shown here is the preferred method of connecting a VCR to your TV if you are in an area with good signal reception. This way you can view either TV programs or VCR tapes and not be concerned about the position of the VCR's TV/VCR switch and you can enjoy stereo tape playback from stereo VCR. • If your lead cable is a 300-ohm twin-lead cable or UHF/VHF separate cable, use a 300/75-ohm adapter or combiner (output side is 75-ohm coaxial) to connect to the TV (see below). Outdoor antenna connection Connecting Antenna Cable Cable without a CATV converter CombinationCable TV lead-In VHF/UHF antenna Home Antenna terminal (75-ohm) or 75-ohm coaxial cable (round) 300/75-ohm adapter (commercially available) 300-ohm twin-lead (flat) Coaxial cable (commercially available) Separate VHF/UHF antenna VHF UHF ANTENNA ANTENNA 300-ohm twin-lead 300-ohm twin-lead or 75-ohm coaxial cable Combiner (commercially available) IN OUT RF Cable (Supplied) NOTICE F-type connector F-type connector should be finger-tightened only. 75-ohm coaxial cable When connecting the RF cable to the TV set, do not tighten F-type connector with tools. If tools are used, it may cause damage to your TV set. (The breaking of internal circuit, etc.) 19