Sharp LC-37D4U LC-26GD4U LC-32GD4U LC-37GD4U Operation Manual - Page 58
Using external equipment, Setting the recording mode i.LINK, Setting the Stand-by Mode i.LINK
UPC - 074000363014
View all Sharp LC-37D4U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Using external equipment Setting the recording mode (i.LINK) Setting the Stand-by Mode (i.LINK) • The function for automatically adjusting the recording mode of connected D-VHS decks can be turned on or off. • Since most of the currently available D-VHS decks automatically recognize the transfer rates of the pictures and sound being recorded and control the recording mode accordingly, you should always set this Mode to "No" in normal circumstances. • Depending on the D-VHS deck used and the type of broadcast being recorded, this TV may not adjust the recording mode properly. In this case, please set the "Recording Mode" to "No". • Power consumption during stand-by mode can be minimized by changing the setting of the "Standby Mode" in "i.LINK Setup". • When i.LINK is not in use, select "No" in "Stand-by Mode". 1 Press MENU to display the MENU. 2 Press c/d to select "Digital Setup". 1 Press MENU and the MENU screen displays. 3 Press a/b to select "i.LINK Setup", and then press ENTER. 2 Press c/d to select "Digital Setup". 4 Press a/b to select "Stand-by Mode", and then press ENTER. 3 Press a/b to select "i.LINK Setup", and then press ENTER. 5 Press c/d to select "Yes" or "No", and then press ENTER. 4 Press a/b to select "Recording Mode", and then press ENTER. "Yes": Power continues to pass through the i.LINK circuit so data can be relayed. "No": Power consumption is minimized during stand- by mode. Data cannot be sent at this setting. 5 Press c/d to select "Yes" or "No", and then press ENTER. NOTE • Normally, this should be set to "No". • When the main power of the TV is in standby mode (POWER indicator lights up in red), i.LINK control commands cannot be received from a D-VHS deck. This does not change even if the "Stand-by Mode" is set to "Yes". To control the TV from a D-VHS deck, turn the TV power on (POWER indicator lights up in green). • Data cannot be relayed between i.LINK devices when all the following conditions are met: 1) More than one i.LINK device is connected to the TV with i.LINK cables, 2) "Stand-by Mode" is set to "No", and 3) The main power of the TV is in standby mode (POWER indicator lights up in red). When the TV is connected between two i.LINK devices in series, select "Yes" in "Stand-by Mode" or connect the TV at an end of the series as shown in the diagram. 57