Sharp MT821 Operation Manual - Page 23

auto-play

Get Sharp MT821 - MiniDisc Recorder - Metallic PDF manuals and user guides
UPC - 074000410473
View all Sharp MT821 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

To interrupt playback: Press the )II button during playback. 0 To resume playback, press the )I1 but- ton again. To stop playback: Press the n /:OFF button. To turn off the power: Press the n /:OFF button while in the stop mode. 0 If the unit is not operated for at least 2 minutes while in the stop mode. the power will shut off automatically. To remove the MiniDisc: Turn off the power and move the OPEN lever in the direction indicated by the arrow. Resume auto play function: 0 When you press the n /:OFF button to stop playback, or when you turn the power off and then you resume playback, it will resume at the point on the MiniDisc where the playback was halted. 0 If the MiniDisc is removed and inserted, and playback is resumed, playback will start from the first track. Precautions when making connections: 0 Do not use any remote control unit, except for the one included with this unit. 0 Do not remove the rubber pads from the headphones. 0 Insert each plug securely, all the way in. 0 Be sure to hold the plug when removing it. If you pull on the cord, it may break, or the unit may malfunction. Interrupted sound: 0 This product is designed to eliminate interruptions in the sound which can be caused by vibrations. However, if the unit is continuously exposed to vibrations or mechanical shock, the sound may be interrupted momentarily. When the sound is distorted: 0 If the volume is too high while the bass is being emphasized, the sound may be distorted, depending on the music on the track. If this happens, decrease the bass level or lower the volume level. 0 If the volume is increased to "VOL 24 or higher, the bass level will be adjusted automatically. (This is done to reduce the distortion in the sound.) Caution: 0 When the unit is not to be used imme- diately after a MiniDisc has been inserted, or when you plan to carry the unit, turn off the power or cancel the auto-play function. Otherwise, the auto-play function will be activated and the battery will run down. 0 Since the main unit and the AC adap- tor can heat up during use, you should avoid allowing the unit to be in direct contact with your skin for any length of time. When using the unit with a car adaptor: 0 When you switch off the ignition key during playback, the power to this unit will also be turned off. Then, when the ignition key is switched on, playback will star-l from the beginning of the track where playback was halted (Resume auto-play function). However, the power to the unit may not be turned off when the ignition is turned off, depending on the type of car. , 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
To interrupt playback:
Press the
)II
button during playback.
0
To resume playback, press the
)I1
but-
ton again.
To stop playback:
Press the
n
/:OFF button.
To turn off the power:
Press the
n
/:OFF button while in the stop
mode.
0
If the unit is not operated for at least 2
minutes while in the stop mode. the
power will shut off automatically.
To remove the
MiniDisc:
Turn
off the power and move the OPEN le-
ver in the direction indicated by the arrow.
Resume auto play function:
0
When you press the
n
/:OFF button to
stop playback, or when you turn the
power off and then you resume play-
back, it will resume at the point on the
MiniDisc where the playback was halted.
0
If the
MiniDisc is removed and inserted,
and playback is resumed, playback will
start from the first track.
Precautions when making
connec-
Caution:
tions:
0
When the unit is not to be used
imme-
0
Do not use any remote control unit,
diately after a
MiniDisc has been
in-
except for the one included with this
serted, or when you plan to carry the
unit.
unit, turn off the power or cancel the
0
Do not remove the rubber pads from
auto-play function. Otherwise, the
the headphones.
auto-play
function will be activated and
0
Insert each plug securely, all the way
the battery will run down.
in.
0
Since the main unit and the AC
adap-
0
Be sure to hold the plug when
remov-
tor can heat up during use, you should
ing it. If you pull on the cord, it may
avoid allowing the unit to be in direct
break, or the unit may malfunction.
contact with your skin for any length
Interrupted
sound:
of time.
0
This product is designed to eliminate
When using the unit with a car adaptor:
interruptions in the sound which can
0
When you switch off the ignition key
be caused by vibrations. However, if
during playback, the power to this unit
the unit is continuously exposed to
will also be turned off. Then, when the
vibrations or mechanical shock, the
ignition key is switched on, playback
sound may be interrupted momen-
will star-l from the beginning of the track
tarily.
where playback was halted (Resume
When
the sound is distorted:
auto-play function). However, the
0
If the volume is too high while the bass
power to the unit may not be turned
is being emphasized, the sound may
off when the ignition is turned off, de-
be distorted, depending on the music
pending on the type of car.
on the track. If this happens, decrease
,
the bass level or lower the volume
level.
0
If the volume is increased to “VOL 24
or higher, the bass level will be ad-
justed automatically.
(This is done to reduce the distortion
in the sound.)
22