Sharp MX-2615N Operating Guide - Page 729

SYSTEM SETTINGS Auto Power Shut-Off Timer Settings that depend on the usage conditions, such as the time till Auto Power Shut-Off is enabled or the time zone for Auto Power Shut-Off can be configured. In case of "Fix transition time", it can be set to "Earliest" or within a range of 1 to 60 minutes. When "As soon as the remote job is finished, enter Auto power shut off mode" is enabled, Auto Power Shut-Off happens in a short while after the print job or fax reception is complete. In case of settings that depend on the usage conditions, select "Change transition time by time of day". As per the default settings, the time zone is set automatically depending on the application conditions of the machine. When it is to be selected manually, you can select from the following. • All Day "Energy Save Priority2" : To be set when you want Auto Power Shut-Off to be enabled in minimum time in any time zone. • 8:00-18:00 "Energy Save Priority1": To be set when this machine is to be used more frequently in this time zone than other time zones. • 8:00-18:00 "Job Start Priority1": To be set when the frequency of use of this machine in this time zone is significantly more. • Settings edited to match the usage conditions, combining the three patterns given above can also be selected. Display Message When Extending Transition Time to Preheat/Auto Power Shut-Off Mode If this checkbox is set to , a message appears asking you whether to delay transition to Preheat Mode or Auto Power Shut Off Mode, 15 seconds before the transition. Power ON/OFF Schedule Setting The machine operator panel can be turned On or Off at a preset time. Up to three patterns can be set. The "Setting 1", "Setting 2" and "Setting 3" are executed in this sequence if set at the same day of week or at the same clock time. • The scheduling function does not support the power management settings in the Preheat Mode and Auto Power Shut-Off Mode. • The preset power-off time is subject to the following restrictions: - If the machine is running due to the current job execution or other reasons, the machine is turned off only after the job has finished. - The machine cannot receive printer jobs. - The machine can receive output jobs, such as received fax data outputs. - If the Time Specified Output of Received Data setting is enabled, they are output next time the machine is turned on. • If the power management setting is also enabled, the Power On/Off Scheduling settings precede. • If the same time is specified, settings are applied in the order of "Setting 1", "Setting 2", and "Setting 3". • The power is not turned off in the following cases: - "Automatic deletion when power is turned on" is in progress - While the optimization of the hard disk is in progress or while a restart is in progress after the setting mode has been changed. - The preset power on/off time is within one minute from when the setting is accepted. Sleep Mode Power Level The "Low Power" setting is a highly effective way to save power, however, it takes some time to wake up. The "Fast Wake Up" setting consumes more power than the "Low Power" setting, however, it shortens the wake up time. 7-62 Contents