Sharp MX-2615N Operating Guide - Page 826

TROUBLESHOOTING Problem Printing is not possible or stops during a job. The original size is not automatically selected or the wrong size is selected. The displayed bypass tray paper size is not correct. Point to check Is a tray out of paper? Is the machine out of toner? Has a paper misfeed occurred? Is the output tray full? Is the waste toner box full? In the Paper Tray Settings of the system settings, are restrictions placed on the trays that can be used in each mode (copy, print, fax, Internet fax, and document filing)? Is the original curled or folded? Did you place an original smaller than 5-1/2" x 8-1/2" (A5) size? Is the bypass tray extension pulled out? Solution Add paper as instructed by the message in the touch panel. Replace the toner cartridge. When toner runs low, a message will appear to inform you that the toner cartridge must be replaced. To replace the toner cartridge, see "MAINTENANCE" (page 1-49) in "1. BEFORE USING THE MACHINE". Remove the misfeed as instructed by the message in the touch panel. ☞ REMOVING MISFEEDS (page 8-8) Remove the output from the tray and resume printing. When the output tray becomes full, a detector activates and stops printing. Replace the waste toner box as instructed by the message in the touch panel. ☞ 1. BEFORE USING THE MACHINE "MAINTENANCE" (page 1-49) Check the Paper Tray Settings and see if checkmarks appear in the checkboxes of each mode (Feeding Approved Job). Functions without a checkmark cannot be used for printing using that tray. ➞ System Settings > "Paper Tray Settings" > "Tray Settings" > "Change" > (Each mode) Straighten the original. The correct original size cannot be detected if the original is curled or folded. Enter the original size manually. Original sizes smaller than 5-1/2" x 8-1/2" (A5) cannot be detected. When scanning a small original on the document glass, it is convenient to place a blank sheet of paper on top of the original which is the same size (8-1/2" x 11" (A4), 8-1/2" x 11"R (B5), etc.) as the paper that you wish to use for printing. Pull out the bypass tray extension. When loading paper in the bypass tray, be sure to pull out the extension to enable the paper size to be detected correctly. 8-40 Contents