Singer 14T968DC PROFESIONAL 5 Instruction Manual 2 - Page 127
Beading Foot
View all Singer 14T968DC PROFESIONAL 5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
BEADING FOOT The Beading Foot is used for sewing on beads, sequins, pearls and thick cord. Machine Preparation • Differential Feed: • Needles: • Upper Knife: • Stitch Length: • Foot: Set to "N" Use left needle for large beads, or right needle for smaller beads You may choose to work with or without the upper knife (If engaging the knife, be careful not to cut the beads as you sew) Set to 3 or 4 Attach (snap-on) Beading Foot Sewing Instructions • Pull the beads along guides 1 and 2 through the back of the foot • Raise the presser foot and place fabric under the foot, with the edge of the fabric lined up with the edge of the Beading Foot • Lower presser foot and begin sewing, slowly at first to make sure the beads are well posi- tioned Note: The needle should penetrate the fabric at 1.5mm away from the edge. Additional Presser Feet page 4