Singer One Instruction Manual 5 - Page 26
Sewing on buttons
View all Singer One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Sewing on buttons Install the darning plate. (A) Change presser foot to button sewing foot. (B) Select zigzag stitch. Position the work under the foot. Place the button on the marked position, lower the foot. Adjust stitch width to "0" and sew a few securing stitches. Set the stitch width to number "3" - "5". Turn the handwheel to check that the needle goes cleanly into the left and right holes of the button (adjust the stitch width according to the button), and slowly sew on the button with about 10 stitches. Adjust the stitch width to "0" and sew a few securing stitches (1). If a shank is required, place a darning needle on top of the button and sew (2). For buttons with 4 holes, sew through the front two holes first (1), push the work forward and then sew through the back two holes as described (2). Stitch width dial (models A & B) 4321 5 A S1 0 432 Stitch length dial (models A, B & C) 0 1 Button sewing foot B S2 1 2 23