Singer S900 INSPIRATION Instruction Manual 2 - Page 13

without

Get Singer S900 INSPIRATION PDF manuals and user guides View all Singer S900 INSPIRATION manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

12 PREPARING TO SEW Have take-up lever at highest point before starting to sew. Do not try to help the feeding by pulling the material as this may deflect the needle and cause it to break. NEVER run machine without material under presser foot. Place material and threads in position under the presser foot and lower the presser foot, You are now ready to begin sewing. By having the needle at its highest point, it is not necessary to touch the hand wheel to start the machine. You merely press the control. The speed of the machine is regulated by increasing or decreasing the amount of pressure exerted on the control. Fig. 19 Fig. 20 REMOVING THE WORK Be sure to stop the machine when the thread take-up lever and needle bar are at the highest position. and pass as not to Now raise the presser foot and draw the fabric back and to the left, the threads over the thread cutter. Pull down slightly, holding thread in bend the needle. Leave the ends of thread under the presser foot. both hands, so

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
12
PREPARING
TO
SEW
Have
take-up
lever
at
highest
point
before
starting
to
sew.
Do
not
try
to
help
the
feeding
by
pulling
the
material
as
this
may
deflect
the
needle
and
cause
it
to
break.
NEVER
run
machine
without
material
under
presser
foot.
Place
material
and
threads
in
position
under
the
presser
foot
and
lower
the
presser
foot,
You
are
now
ready
to
begin
sewing.
By
having
the
needle
at
its
highest
point,
it
is
not
necessary
to
touch
the
hand
wheel
to
start
the
machine.
You
merely
press
the
control.
The
speed
of
the
machine
is
regulated
by
increasing
or
decreasing
the
amount
of
pressure
exerted
on
the
control.
REMOVING
THE
WORK
Be
sure
to
stop
the
machine
when
the
thread
take-up
lever
and
needle
bar
are
at
the
highest
position.
Now
raise
the
presser
foot
and
draw
the
fabric
back
and
to
the
left,
and
pass
the
threads
over
the
thread
cutter.
Pull
down
slightly,
holding
thread
in
both
hands,
so
as
not
to
bend
the
needle.
Leave
the
ends
of
thread
under
the
presser
foot.
Fig.
19
Fig.
20