Sony BM850T2 Operating Instructions - Page 14

Transcription continued

Page 14 highlights

Transcription (continued) Note If the LTR or SEC signal is detected while the tape is being rewound with this function, the length of the reverse time may be longer than the setting you have selected. Auto backspace function This control operates only when the foot control unit is connected. With the use of the REVERSE TIME control, the tape is rewound a little each time it is stopped. Then, the last few recorded words can be reviewed when you resume listening. Adjust the REVERSE TIME control to determine the length of tape to be rewound. At "9" position, the tape is rewound so that the dictated material can be reviewed for about 5 seconds*. At "0" position, the tape stops without being rewound at all. Set the REVERSE TIME control to the desired position and keep the right side of the pedal depressed to listen to the tape. * Measured at some point near the middle of the tape. The reverse time will vary in accordance with the remaining length of the tape. REVERSE TIME : at "9" position Playback STOP is pressed at this point. Tape REVERSE TIME : at "0" position approx. 5 seconds playback Next playback will start from this point. STOP is pressed at this point. Playback Tape playback Next playback will start from this point. Notes • When the button is pressed while detecting the index signal during playback, the switching time of the operation modes may be delayed. • When a cassette which was not recorded using a Sony Professional Dictating Machine (BM-531, 560, 570, 577, 820, 880, 890, etc.) is played back or wound rapidly (in fast forward or rewind mode), the switching time of the operation modes may be delayed. In this case, set the unit to the Electronic "Index OFF" mode. (See page 15.) Tape transport operation To BM-850 Hand control unit Foot control unit Rewind Press 0 REW. Keep the function Keep the left side of the selector pressed down pedal depressed. toward B.SPACE. Stop Press p STOP. Set the function selector to STOP. Release the pedal. Listen Press ( LISTEN. Set the function Keep the right side of selector to LISTEN. the pedal depressed. Fast Press ) FF. Keep the FWD SPACE Keep the top center of forward button pressed. the pedal depressed. 14 Operations

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

BM-850D/T 3-757-398-32 U E
14
Operations
Transcription (continued)
Auto backspace function
This control operates only when the foot control unit is connected.
With the use of the REVERSE TIME control, the tape is rewound a little
each time it is stopped. Then, the last few recorded words can be reviewed
when you resume listening. Adjust the REVERSE TIME control to
determine the length of tape to be rewound.
At “9” position, the tape is rewound so that the dictated material can be
reviewed for about 5 seconds*. At “0” position, the tape stops without
being rewound at all.
Set the REVERSE TIME control to the desired position and keep the right
side of the pedal depressed to listen to the tape.
*
Measured at some point near the middle of the tape. The reverse time will vary in
accordance with the remaining length of the tape.
Tape transport operation
To
BM-850
Hand control unit
Foot control unit
Rewind
Press
0
REW.
Keep the function
Keep the left side of the
selector pressed down
pedal depressed.
toward B.SPACE.
Stop
Press
p
STOP.
Set the function
Release the pedal.
selector to STOP.
Listen
Press
(
Set the function
Keep the right side of
LISTEN.
selector to LISTEN.
the pedal depressed.
Fast
Press
)
FF.
Keep the FWD SPACE
Keep the top center of
forward
button pressed.
the pedal depressed.
REVERSE TIME : at “9” position
Next playback will start from this point.
approx. 5 seconds
STOP is pressed at this point.
Tape
Playback
playback
REVERSE TIME : at “0” position
STOP is pressed at this point.
Next playback will start from this point.
playback
Playback
Tape
Notes
When the button is pressed
while detecting the index signal
during playback, the switching
time of the operation modes
may be delayed.
When a cassette which was not
recorded using a Sony
Professional Dictating Machine
(BM-531, 560, 570, 577, 820, 880,
890, etc.) is played back or
wound rapidly (in fast forward
or rewind mode), the switching
time of the operation modes
may be delayed. In this case, set
the unit to the Electronic “Index
OFF” mode. (See page 15.)
Note
If the LTR or SEC signal is
detected while the tape is being
rewound with this function, the
length of the reverse time may be
longer than the setting you have
selected.