Sony CMT-LS1 Operating Instructions - Page 27

AM antenna Connect a 6- to 15- meter (20- to 50- feet) insulated wire to the AM antenna terminal. Leave the supplied AM loop antenna connected. Insulated wire (not supplied) Important If you connect an external antenna, connect the ground wire to the U terminal. To prevent a gas explosion, do not connect the ground wire to a gas pipe. Additional Information Precautions On safety • The system is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the system itself has been turned off. • Unplug the system from the wall outlet if it is not to be used for an extended period of time. To disconnect the cord (mains lead), pull it out by the plug. Never pull the cord itself. • Should any solid object or liquid fall into the system, unplug the system and have it checked by qualified personnel before operating it any further. • The AC power cord must be changed only at the qualified service shop. • When you connect the AC power cord to the wall outlet (mains), even though the power is off, the system begins charging for remote and timer functions. Therefore the surface of this unit becomes warm, this is normal. • The nameplate indicating operating voltage, power consumption, etc. is located at the rear. On placement • Place the system in a location with adequate air circulation, and do not place anything on the system. • Place the system in a location with adequate ventilation to prevent heat build up. • Do not place the system in an inclined position. • Do not place the system in locations where it is; - Extremely hot or cold - Dusty or dirty - Very humid - Subject to vibrations - Subject to direct sunlight. On installing When you move the system, remove all discs. continued Optional Components/Additional Information 27