Sony CMT-LS1 Operating Instructions - Page 28
Troubleshooting, General
View all Sony CMT-LS1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Precautions (continued) On operation • You cannot play 8 cm CDs with this system. • If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player. Should this occur, the system will not operate properly. Remove the CD and leave the system turned on for about 2 hours until the moisture evaporates. If you have any questions or problems concerning your system, please consult your nearest Sony dealer. On the speaker system This speaker system is not magnetically shielded and the picture on TV sets may become magnetically distorted. In such a case, turn off the power of the TV set once, and after 15 to 30 minutes turn it on again. If there seems to be no improvement, locate the speaker system further away from the TV set. Also, be sure not to place objects in which magnets are attached or used near the TV set, such as audio racks, TV stands and toys. These may cause magnetic distortion to the picture due to their interaction with the system. Notes on CDs • Do not use a CD with tape, stickers, or paste on it as this may damage the player. • Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out. Do not use solvents such as benzine, thinner, commercially available cleaners, or antistatic spray intended for vinyl LPs. • Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight. Cleaning the cabinet Use a soft cloth slightly moistened with mild detergent solution. Troubleshooting If you have any problem using this system, use the following checklist. First, check that the AC power cord is connected firmly and that the speakers are connected correctly and firmly. Should any problem persist, consult your nearest Sony dealer. General There is no sound. • Press VOLUME +. • Make sure the headphones are not connected. • Check the speaker connections. There is severe hum or noise. • A TV or VCR is placed too close to the system. Move the system away from the TV or VCR. "0:00" (or "12:00AM") flashes in the display. • A power failure occurred. Set the clock and timer settings again. The timer does not function. • Set the clock correctly. The remote does not function. • There is an obstacle between the remote and the system. • The remote is not pointing in the direction of the system's sensor. • The battery have run down. Replace the battery. • Do not place the system in locations where it is near an electric inverter system. The front panel does not open when you bring your hand near. • The PANEL OPEN switch is set to MANUAL. Set the switch to ON/AUTO or AUTO. 28